diff mbox series

[03/14] regulator: core: enable power when setting up constraints

Message ID 1e2f8f5a5eeebd40431675675569012cb8e17473.1543245984.git-series.plaes@plaes.org (mailing list archive)
State Not Applicable, archived
Headers show
Series regulator: axp20x: Stop AXP209 from crashing when enabling LDO3 | expand

Commit Message

Priit Laes Nov. 26, 2018, 3:27 p.m. UTC 
From: Olliver Schinagl <oliver@schinagl.nl>

When a regulator is marked as always on, it is enabled early on, when
checking and setting up constraints. It makes the assumption that the
bootloader properly initialized the regulator, and just in case enables
the regulator anyway.

Some constraints however currently get missed, such as the soft-start
and ramp-delay. This causes the regulator to be enabled, without the
soft-start and ramp-delay being applied, which in turn can cause
high-currents or other start-up problems.

By moving the always-enabled constraints later in the constraints check,
we can at least ensure all constraints for the regulator are followed.

Signed-off-by: Olliver Schinagl <oliver@schinagl.nl>
Signed-off-by: Priit Laes <plaes@plaes.org>
---
 drivers/regulator/core.c | 22 +++++++++++-----------
 1 file changed, 11 insertions(+), 11 deletions(-)
diff mbox series

Patch

diff --git a/drivers/regulator/core.c b/drivers/regulator/core.c
index 2c66b52..6e14610 100644
--- a/drivers/regulator/core.c
+++ b/drivers/regulator/core.c
@@ -1158,17 +1158,6 @@  static int set_machine_constraints(struct regulator_dev *rdev,
 		}
 	}
 
-	/* If the constraints say the regulator should be on at this point
-	 * and we have control then make sure it is enabled.
-	 */
-	if (rdev->constraints->always_on || rdev->constraints->boot_on) {
-		ret = _regulator_do_enable(rdev);
-		if (ret < 0 && ret != -EINVAL) {
-			rdev_err(rdev, "failed to enable\n");
-			return ret;
-		}
-	}
-
 	if ((rdev->constraints->ramp_delay || rdev->constraints->ramp_disable)
 		&& ops->set_ramp_delay) {
 		ret = ops->set_ramp_delay(rdev, rdev->constraints->ramp_delay);
@@ -1214,6 +1203,17 @@  static int set_machine_constraints(struct regulator_dev *rdev,
 		}
 	}
 
+	/* If the constraints say the regulator should be on at this point
+	 * and we have control then make sure it is enabled.
+	 */
+	if (rdev->constraints->always_on || rdev->constraints->boot_on) {
+		ret = _regulator_do_enable(rdev);
+		if (ret < 0 && ret != -EINVAL) {
+			rdev_err(rdev, "failed to enable\n");
+			return ret;
+		}
+	}
+
 	print_constraints(rdev);
 	return 0;
 }