Message ID | 2841b1a86987564f14f15ec5b59f6a8bead86b30.1684397037.git.matsuda-daisuke@fujitsu.com (mailing list archive) |
---|---|
State | Not Applicable |
Headers | show |
Series | On-Demand Paging on SoftRoCE | expand |
On 5/18/23 03:21, Daisuke Matsuda wrote: > Enable 'fetch and add' and 'compare and swap' operations to manipulate > data in an ODP-enabled MR. This is comprised of the following steps: > 1. Check the driver page table(umem_odp->dma_list) to see if the target > page is both readable and writable. > 2. If not, then trigger page fault to map the page. > 3. Update the entry in the MR xarray. > 4. Execute the operation. > > umem_mutex is used to ensure that dma_list (an array of addresses of an MR) > is not changed while it is being checked and that the target page is not > invalidated before data access completes. > > Signed-off-by: Daisuke Matsuda <matsuda-daisuke@fujitsu.com> > --- > drivers/infiniband/sw/rxe/rxe.c | 1 + > drivers/infiniband/sw/rxe/rxe_loc.h | 9 +++++++++ > drivers/infiniband/sw/rxe/rxe_odp.c | 26 ++++++++++++++++++++++++++ > drivers/infiniband/sw/rxe/rxe_resp.c | 5 ++++- > 4 files changed, 40 insertions(+), 1 deletion(-) > > diff --git a/drivers/infiniband/sw/rxe/rxe.c b/drivers/infiniband/sw/rxe/rxe.c > index 207a022156f0..abd3267c2873 100644 > --- a/drivers/infiniband/sw/rxe/rxe.c > +++ b/drivers/infiniband/sw/rxe/rxe.c > @@ -88,6 +88,7 @@ static void rxe_init_device_param(struct rxe_dev *rxe) > rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_RECV; > rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_WRITE; > rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_READ; > + rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_ATOMIC; > rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_SRQ_RECV; > } > } > diff --git a/drivers/infiniband/sw/rxe/rxe_loc.h b/drivers/infiniband/sw/rxe/rxe_loc.h > index 4b95c8c46bdc..b9d2985774ee 100644 > --- a/drivers/infiniband/sw/rxe/rxe_loc.h > +++ b/drivers/infiniband/sw/rxe/rxe_loc.h > @@ -208,6 +208,9 @@ int rxe_odp_mr_init_user(struct rxe_dev *rxe, u64 start, u64 length, > u64 iova, int access_flags, struct rxe_mr *mr); > int rxe_odp_mr_copy(struct rxe_mr *mr, u64 iova, void *addr, int length, > enum rxe_mr_copy_dir dir); > +int rxe_odp_mr_atomic_op(struct rxe_mr *mr, u64 iova, int opcode, > + u64 compare, u64 swap_add, u64 *orig_val); > + > #else /* CONFIG_INFINIBAND_ON_DEMAND_PAGING */ > static inline int > rxe_odp_mr_init_user(struct rxe_dev *rxe, u64 start, u64 length, u64 iova, > @@ -221,6 +224,12 @@ rxe_odp_mr_copy(struct rxe_mr *mr, u64 iova, void *addr, > { > return -EOPNOTSUPP; > } > +static inline int > +rxe_odp_mr_atomic_op(struct rxe_mr *mr, u64 iova, int opcode, > + u64 compare, u64 swap_add, u64 *orig_val) > +{ > + return RESPST_ERR_UNSUPPORTED_OPCODE; > +} > > #endif /* CONFIG_INFINIBAND_ON_DEMAND_PAGING */ > > diff --git a/drivers/infiniband/sw/rxe/rxe_odp.c b/drivers/infiniband/sw/rxe/rxe_odp.c > index cbe5d0c3fcc4..194b1fab98b7 100644 > --- a/drivers/infiniband/sw/rxe/rxe_odp.c > +++ b/drivers/infiniband/sw/rxe/rxe_odp.c > @@ -283,3 +283,29 @@ int rxe_odp_mr_copy(struct rxe_mr *mr, u64 iova, void *addr, int length, > > return err; > } > + > +int rxe_odp_mr_atomic_op(struct rxe_mr *mr, u64 iova, int opcode, > + u64 compare, u64 swap_add, u64 *orig_val) > +{ > + int err; > + struct ib_umem_odp *umem_odp = to_ib_umem_odp(mr->umem); > + > + /* If pagefault is not required, umem mutex will be held until the > + * atomic operation completes. Otherwise, it is released and locked > + * again in rxe_odp_map_range() to let invalidation handler do its > + * work meanwhile. > + */ > + mutex_lock(&umem_odp->umem_mutex); > + > + /* Atomic operations manipulate a single char. */ > + err = rxe_odp_map_range(mr, iova, sizeof(char), 0); > + if (err) > + return err; > + > + err = rxe_mr_do_atomic_op(mr, iova, opcode, compare, > + swap_add, orig_val); > + > + mutex_unlock(&umem_odp->umem_mutex); > + > + return err; > +} > diff --git a/drivers/infiniband/sw/rxe/rxe_resp.c b/drivers/infiniband/sw/rxe/rxe_resp.c > index 90c31c4f2944..0a918145dc07 100644 > --- a/drivers/infiniband/sw/rxe/rxe_resp.c > +++ b/drivers/infiniband/sw/rxe/rxe_resp.c > @@ -684,7 +684,10 @@ static enum resp_states atomic_reply(struct rxe_qp *qp, > u64 iova = qp->resp.va + qp->resp.offset; > > if (mr->odp_enabled) > - err = RESPST_ERR_UNSUPPORTED_OPCODE; > + err = rxe_odp_mr_atomic_op(mr, iova, pkt->opcode, > + atmeth_comp(pkt), > + atmeth_swap_add(pkt), > + &res->atomic.orig_val); > else > err = rxe_mr_do_atomic_op(mr, iova, pkt->opcode, > atmeth_comp(pkt), Reviewed-by: Bob Pearson <rpearsonhpe@gmail.com>
diff --git a/drivers/infiniband/sw/rxe/rxe.c b/drivers/infiniband/sw/rxe/rxe.c index 207a022156f0..abd3267c2873 100644 --- a/drivers/infiniband/sw/rxe/rxe.c +++ b/drivers/infiniband/sw/rxe/rxe.c @@ -88,6 +88,7 @@ static void rxe_init_device_param(struct rxe_dev *rxe) rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_RECV; rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_WRITE; rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_READ; + rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_ATOMIC; rxe->attr.odp_caps.per_transport_caps.rc_odp_caps |= IB_ODP_SUPPORT_SRQ_RECV; } } diff --git a/drivers/infiniband/sw/rxe/rxe_loc.h b/drivers/infiniband/sw/rxe/rxe_loc.h index 4b95c8c46bdc..b9d2985774ee 100644 --- a/drivers/infiniband/sw/rxe/rxe_loc.h +++ b/drivers/infiniband/sw/rxe/rxe_loc.h @@ -208,6 +208,9 @@ int rxe_odp_mr_init_user(struct rxe_dev *rxe, u64 start, u64 length, u64 iova, int access_flags, struct rxe_mr *mr); int rxe_odp_mr_copy(struct rxe_mr *mr, u64 iova, void *addr, int length, enum rxe_mr_copy_dir dir); +int rxe_odp_mr_atomic_op(struct rxe_mr *mr, u64 iova, int opcode, + u64 compare, u64 swap_add, u64 *orig_val); + #else /* CONFIG_INFINIBAND_ON_DEMAND_PAGING */ static inline int rxe_odp_mr_init_user(struct rxe_dev *rxe, u64 start, u64 length, u64 iova, @@ -221,6 +224,12 @@ rxe_odp_mr_copy(struct rxe_mr *mr, u64 iova, void *addr, { return -EOPNOTSUPP; } +static inline int +rxe_odp_mr_atomic_op(struct rxe_mr *mr, u64 iova, int opcode, + u64 compare, u64 swap_add, u64 *orig_val) +{ + return RESPST_ERR_UNSUPPORTED_OPCODE; +} #endif /* CONFIG_INFINIBAND_ON_DEMAND_PAGING */ diff --git a/drivers/infiniband/sw/rxe/rxe_odp.c b/drivers/infiniband/sw/rxe/rxe_odp.c index cbe5d0c3fcc4..194b1fab98b7 100644 --- a/drivers/infiniband/sw/rxe/rxe_odp.c +++ b/drivers/infiniband/sw/rxe/rxe_odp.c @@ -283,3 +283,29 @@ int rxe_odp_mr_copy(struct rxe_mr *mr, u64 iova, void *addr, int length, return err; } + +int rxe_odp_mr_atomic_op(struct rxe_mr *mr, u64 iova, int opcode, + u64 compare, u64 swap_add, u64 *orig_val) +{ + int err; + struct ib_umem_odp *umem_odp = to_ib_umem_odp(mr->umem); + + /* If pagefault is not required, umem mutex will be held until the + * atomic operation completes. Otherwise, it is released and locked + * again in rxe_odp_map_range() to let invalidation handler do its + * work meanwhile. + */ + mutex_lock(&umem_odp->umem_mutex); + + /* Atomic operations manipulate a single char. */ + err = rxe_odp_map_range(mr, iova, sizeof(char), 0); + if (err) + return err; + + err = rxe_mr_do_atomic_op(mr, iova, opcode, compare, + swap_add, orig_val); + + mutex_unlock(&umem_odp->umem_mutex); + + return err; +} diff --git a/drivers/infiniband/sw/rxe/rxe_resp.c b/drivers/infiniband/sw/rxe/rxe_resp.c index 90c31c4f2944..0a918145dc07 100644 --- a/drivers/infiniband/sw/rxe/rxe_resp.c +++ b/drivers/infiniband/sw/rxe/rxe_resp.c @@ -684,7 +684,10 @@ static enum resp_states atomic_reply(struct rxe_qp *qp, u64 iova = qp->resp.va + qp->resp.offset; if (mr->odp_enabled) - err = RESPST_ERR_UNSUPPORTED_OPCODE; + err = rxe_odp_mr_atomic_op(mr, iova, pkt->opcode, + atmeth_comp(pkt), + atmeth_swap_add(pkt), + &res->atomic.orig_val); else err = rxe_mr_do_atomic_op(mr, iova, pkt->opcode, atmeth_comp(pkt),
Enable 'fetch and add' and 'compare and swap' operations to manipulate data in an ODP-enabled MR. This is comprised of the following steps: 1. Check the driver page table(umem_odp->dma_list) to see if the target page is both readable and writable. 2. If not, then trigger page fault to map the page. 3. Update the entry in the MR xarray. 4. Execute the operation. umem_mutex is used to ensure that dma_list (an array of addresses of an MR) is not changed while it is being checked and that the target page is not invalidated before data access completes. Signed-off-by: Daisuke Matsuda <matsuda-daisuke@fujitsu.com> --- drivers/infiniband/sw/rxe/rxe.c | 1 + drivers/infiniband/sw/rxe/rxe_loc.h | 9 +++++++++ drivers/infiniband/sw/rxe/rxe_odp.c | 26 ++++++++++++++++++++++++++ drivers/infiniband/sw/rxe/rxe_resp.c | 5 ++++- 4 files changed, 40 insertions(+), 1 deletion(-)