@@ -1267,6 +1267,7 @@ EXPORT_SYMBOL(rproc_resource_cleanup);
static int rproc_set_rsc_table_on_start(struct rproc *rproc, const struct firmware *fw)
{
struct resource_table *loaded_table;
+ struct device *dev = &rproc->dev;
/*
* The starting device has been given the rproc->cached_table as the
@@ -1276,12 +1277,21 @@ static int rproc_set_rsc_table_on_start(struct rproc *rproc, const struct firmwa
* this information to device memory. We also update the table_ptr so
* that any subsequent changes will be applied to the loaded version.
*/
- loaded_table = rproc_find_loaded_rsc_table(rproc, fw);
- if (loaded_table) {
- memcpy(loaded_table, rproc->cached_table, rproc->table_sz);
- rproc->table_ptr = loaded_table;
+ if (rproc->tee_interface) {
+ loaded_table = rproc_get_loaded_rsc_table(rproc, &rproc->table_sz);
+ if (IS_ERR(loaded_table)) {
+ dev_err(dev, "can't get resource table\n");
+ return PTR_ERR(loaded_table);
+ }
+ } else {
+ loaded_table = rproc_find_loaded_rsc_table(rproc, fw);
}
+ if (loaded_table && rproc->cached_table)
+ memcpy(loaded_table, rproc->cached_table, rproc->table_sz);
+
+ rproc->table_ptr = loaded_table;
+
return 0;
}
@@ -1318,11 +1328,16 @@ static int rproc_reset_rsc_table_on_stop(struct rproc *rproc)
kfree(rproc->clean_table);
out:
- /*
- * Use a copy of the resource table for the remainder of the
- * shutdown process.
+ /* If the remoteproc_tee interface is used, then we have first to unmap the resource table
+ * before updating the proc->table_ptr reference.
*/
- rproc->table_ptr = rproc->cached_table;
+ if (!rproc->tee_interface) {
+ /*
+ * Use a copy of the resource table for the remainder of the
+ * shutdown process.
+ */
+ rproc->table_ptr = rproc->cached_table;
+ }
return 0;
}
1) on start: - Using the TEE loader, the resource table is loaded by an external entity. In such case the resource table address is not find from the firmware but provided by the TEE remoteproc framework. Use the rproc_get_loaded_rsc_table instead of rproc_find_loaded_rsc_table - test that rproc->cached_table is not null before performing the memcpy 2)on stop The use of the cached_table seems mandatory: - during recovery sequence to have a snapshot of the resource table resources used, - on stop to allow for the deinitialization of resources after the the remote processor has been shutdown. However if the TEE interface is being used, we first need to unmap the table_ptr before setting it to rproc->cached_table. The update of rproc->table_ptr to rproc->cached_table is performed in tee_remoteproc. Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen@foss.st.com> --- drivers/remoteproc/remoteproc_core.c | 31 +++++++++++++++++++++------- 1 file changed, 23 insertions(+), 8 deletions(-)