Message ID | 1516206496-16612-15-git-send-email-yamada.masahiro@socionext.com (mailing list archive) |
---|---|
State | Accepted |
Delegated to: | Geert Uytterhoeven |
Headers | show |
On Thu, Jan 18, 2018 at 01:28:14AM +0900, Masahiro Yamada wrote: > As far as I tested the IP on UniPhier SoCs, TMIO_STAT_{RXRDY,TXRQ} > are asserted for DMA mode as well as for PIO. I need to disable the > those IRQs in dma_ops->start hook, otherwise the DMA transfer fails > with the following error message: > PIO IRQ in DMA mode! > > Renesas chips are the same cases since I see their dma_ops->start > hooks explicitly clear TMIO_STAT_{RXRDY,TXRQ} (with nice comment!). > > If we do this sanity check in TMIO MMC core, RXRDY/TXRQ handling > should be entirely moved to the core. tmio_mmc_cmd_irq() will > be a suitable place to disable them. > > The probe function sets TMIO_MASK_{READOP,WRITEOP} but this is odd. > > /* Unmask the IRQs we want to know about */ > if (!_host->chan_rx) > irq_mask |= TMIO_MASK_READOP; > if (!_host->chan_tx) > irq_mask |= TMIO_MASK_WRITEOP; > > At this point, _host->{chan_rx,chan_tx} are _always_ NULL because > tmio_mmc_request_dma() is called after this code. Consequently, > TMIO_MASK_{READOP,WRITEOP} are set here whether DMA is used or not. > Remove this pointless code. > > Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> I need to stop reviewing here because I'd need the applied version for checking. I hope Ulf can give me a base tomorrow. Or Yamada-san, do you meanwhile have a git repo somewhere?
2018-02-08 6:47 GMT+09:00 Wolfram Sang <wsa@the-dreams.de>: > On Thu, Jan 18, 2018 at 01:28:14AM +0900, Masahiro Yamada wrote: >> As far as I tested the IP on UniPhier SoCs, TMIO_STAT_{RXRDY,TXRQ} >> are asserted for DMA mode as well as for PIO. I need to disable the >> those IRQs in dma_ops->start hook, otherwise the DMA transfer fails >> with the following error message: >> PIO IRQ in DMA mode! >> >> Renesas chips are the same cases since I see their dma_ops->start >> hooks explicitly clear TMIO_STAT_{RXRDY,TXRQ} (with nice comment!). >> >> If we do this sanity check in TMIO MMC core, RXRDY/TXRQ handling >> should be entirely moved to the core. tmio_mmc_cmd_irq() will >> be a suitable place to disable them. >> >> The probe function sets TMIO_MASK_{READOP,WRITEOP} but this is odd. >> >> /* Unmask the IRQs we want to know about */ >> if (!_host->chan_rx) >> irq_mask |= TMIO_MASK_READOP; >> if (!_host->chan_tx) >> irq_mask |= TMIO_MASK_WRITEOP; >> >> At this point, _host->{chan_rx,chan_tx} are _always_ NULL because >> tmio_mmc_request_dma() is called after this code. Consequently, >> TMIO_MASK_{READOP,WRITEOP} are set here whether DMA is used or not. >> Remove this pointless code. >> >> Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> > > I need to stop reviewing here because I'd need the applied version for > checking. I hope Ulf can give me a base tomorrow. > > Or Yamada-san, do you meanwhile have a git repo somewhere? > Patch 1-6 were pulled merged in this MW. Patch 7-16 are cleanly applicable onto Linus' tree. (commit 581e400ff935d34 as of writing)
On Thu, Jan 18, 2018 at 01:28:14AM +0900, Masahiro Yamada wrote: > As far as I tested the IP on UniPhier SoCs, TMIO_STAT_{RXRDY,TXRQ} > are asserted for DMA mode as well as for PIO. I need to disable the > those IRQs in dma_ops->start hook, otherwise the DMA transfer fails > with the following error message: > PIO IRQ in DMA mode! > > Renesas chips are the same cases since I see their dma_ops->start > hooks explicitly clear TMIO_STAT_{RXRDY,TXRQ} (with nice comment!). > > If we do this sanity check in TMIO MMC core, RXRDY/TXRQ handling > should be entirely moved to the core. tmio_mmc_cmd_irq() will > be a suitable place to disable them. > > The probe function sets TMIO_MASK_{READOP,WRITEOP} but this is odd. > > /* Unmask the IRQs we want to know about */ > if (!_host->chan_rx) > irq_mask |= TMIO_MASK_READOP; > if (!_host->chan_tx) > irq_mask |= TMIO_MASK_WRITEOP; > > At this point, _host->{chan_rx,chan_tx} are _always_ NULL because > tmio_mmc_request_dma() is called after this code. Consequently, > TMIO_MASK_{READOP,WRITEOP} are set here whether DMA is used or not. > Remove this pointless code. > > Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
diff --git a/drivers/mmc/host/renesas_sdhi_internal_dmac.c b/drivers/mmc/host/renesas_sdhi_internal_dmac.c index 0d1f95e..693ad49 100644 --- a/drivers/mmc/host/renesas_sdhi_internal_dmac.c +++ b/drivers/mmc/host/renesas_sdhi_internal_dmac.c @@ -145,7 +145,6 @@ renesas_sdhi_internal_dmac_start_dma(struct tmio_mmc_host *host, u32 dtran_mode = DTRAN_MODE_BUS_WID_TH | DTRAN_MODE_ADDR_MODE; enum dma_data_direction dir; int ret; - u32 irq_mask; /* This DMAC cannot handle if sg_len is not 1 */ WARN_ON(host->sg_len > 1); @@ -157,11 +156,9 @@ renesas_sdhi_internal_dmac_start_dma(struct tmio_mmc_host *host, if (data->flags & MMC_DATA_READ) { dtran_mode |= DTRAN_MODE_CH_NUM_CH1; dir = DMA_FROM_DEVICE; - irq_mask = TMIO_STAT_RXRDY; } else { dtran_mode |= DTRAN_MODE_CH_NUM_CH0; dir = DMA_TO_DEVICE; - irq_mask = TMIO_STAT_TXRQ; } ret = dma_map_sg(&host->pdev->dev, sg, host->sg_len, dir); @@ -170,9 +167,6 @@ renesas_sdhi_internal_dmac_start_dma(struct tmio_mmc_host *host, renesas_sdhi_internal_dmac_enable_dma(host, true); - /* disable PIO irqs to avoid "PIO IRQ in DMA mode!" */ - tmio_mmc_disable_mmc_irqs(host, irq_mask); - /* set dma parameters */ renesas_sdhi_internal_dmac_dm_write(host, DM_CM_DTRAN_MODE, dtran_mode); diff --git a/drivers/mmc/host/renesas_sdhi_sys_dmac.c b/drivers/mmc/host/renesas_sdhi_sys_dmac.c index afdb66b..393df17 100644 --- a/drivers/mmc/host/renesas_sdhi_sys_dmac.c +++ b/drivers/mmc/host/renesas_sdhi_sys_dmac.c @@ -205,8 +205,6 @@ static void renesas_sdhi_sys_dmac_start_dma_rx(struct tmio_mmc_host *host) return; } - tmio_mmc_disable_mmc_irqs(host, TMIO_STAT_RXRDY); - /* The only sg element can be unaligned, use our bounce buffer then */ if (!aligned) { sg_init_one(&host->bounce_sg, host->bounce_buf, sg->length); @@ -280,8 +278,6 @@ static void renesas_sdhi_sys_dmac_start_dma_tx(struct tmio_mmc_host *host) return; } - tmio_mmc_disable_mmc_irqs(host, TMIO_STAT_TXRQ); - /* The only sg element can be unaligned, use our bounce buffer then */ if (!aligned) { unsigned long flags; diff --git a/drivers/mmc/host/tmio_mmc_core.c b/drivers/mmc/host/tmio_mmc_core.c index 0e3dc8c..731552a 100644 --- a/drivers/mmc/host/tmio_mmc_core.c +++ b/drivers/mmc/host/tmio_mmc_core.c @@ -621,15 +621,21 @@ static void tmio_mmc_cmd_irq(struct tmio_mmc_host *host, unsigned int stat) */ if (host->data && (!cmd->error || cmd->error == -EILSEQ)) { if (host->data->flags & MMC_DATA_READ) { - if (host->force_pio || !host->chan_rx) + if (host->force_pio || !host->chan_rx) { tmio_mmc_enable_mmc_irqs(host, TMIO_MASK_READOP); - else + } else { + tmio_mmc_disable_mmc_irqs(host, + TMIO_MASK_READOP); tasklet_schedule(&host->dma_issue); + } } else { - if (host->force_pio || !host->chan_tx) + if (host->force_pio || !host->chan_tx) { tmio_mmc_enable_mmc_irqs(host, TMIO_MASK_WRITEOP); - else + } else { + tmio_mmc_disable_mmc_irqs(host, + TMIO_MASK_WRITEOP); tasklet_schedule(&host->dma_issue); + } } } else { schedule_work(&host->done); @@ -1287,12 +1293,6 @@ int tmio_mmc_host_probe(struct tmio_mmc_host *_host) _host->sdcard_irq_mask = sd_ctrl_read16_and_16_as_32(_host, CTL_IRQ_MASK); tmio_mmc_disable_mmc_irqs(_host, TMIO_MASK_ALL); - /* Unmask the IRQs we want to know about */ - if (!_host->chan_rx) - irq_mask |= TMIO_MASK_READOP; - if (!_host->chan_tx) - irq_mask |= TMIO_MASK_WRITEOP; - _host->sdcard_irq_mask &= ~irq_mask; if (_host->native_hotplug)
As far as I tested the IP on UniPhier SoCs, TMIO_STAT_{RXRDY,TXRQ} are asserted for DMA mode as well as for PIO. I need to disable the those IRQs in dma_ops->start hook, otherwise the DMA transfer fails with the following error message: PIO IRQ in DMA mode! Renesas chips are the same cases since I see their dma_ops->start hooks explicitly clear TMIO_STAT_{RXRDY,TXRQ} (with nice comment!). If we do this sanity check in TMIO MMC core, RXRDY/TXRQ handling should be entirely moved to the core. tmio_mmc_cmd_irq() will be a suitable place to disable them. The probe function sets TMIO_MASK_{READOP,WRITEOP} but this is odd. /* Unmask the IRQs we want to know about */ if (!_host->chan_rx) irq_mask |= TMIO_MASK_READOP; if (!_host->chan_tx) irq_mask |= TMIO_MASK_WRITEOP; At this point, _host->{chan_rx,chan_tx} are _always_ NULL because tmio_mmc_request_dma() is called after this code. Consequently, TMIO_MASK_{READOP,WRITEOP} are set here whether DMA is used or not. Remove this pointless code. Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- Changes in v3: - Remove the first paragraph of git-log - Clean up renesas drivers too Changes in v2: - Newly added drivers/mmc/host/renesas_sdhi_internal_dmac.c | 6 ------ drivers/mmc/host/renesas_sdhi_sys_dmac.c | 4 ---- drivers/mmc/host/tmio_mmc_core.c | 20 ++++++++++---------- 3 files changed, 10 insertions(+), 20 deletions(-)