@@ -99,8 +99,14 @@ static void rzg2l_irq_eoi(struct irq_data *d)
* ISCR can only be cleared if the type is falling-edge, rising-edge or
* falling/rising-edge.
*/
- if ((iscr & bit) && (iitsr & IITSR_IITSEL_MASK(hw_irq)))
+ if ((iscr & bit) && (iitsr & IITSR_IITSEL_MASK(hw_irq))) {
writel_relaxed(iscr & ~bit, priv->base + ISCR);
+ /*
+ * Enforce that the posted write is flushed to prevent that the
+ * just handled interrupt is raised again.
+ */
+ readl_relaxed(priv->base + ISCR);
+ }
}
static void rzg2l_tint_eoi(struct irq_data *d)
@@ -111,8 +117,14 @@ static void rzg2l_tint_eoi(struct irq_data *d)
u32 reg;
reg = readl_relaxed(priv->base + TSCR);
- if (reg & bit)
+ if (reg & bit) {
writel_relaxed(reg & ~bit, priv->base + TSCR);
+ /*
+ * Enforce that the posted write is flushed to prevent that the
+ * just handled interrupt is raised again.
+ */
+ readl_relaxed(priv->base + TSCR);
+ }
}
static void rzg2l_irqc_eoi(struct irq_data *d)
The irq_eoi() callback of the RZ/G2L interrupt chip clears the relevant interrupt cause bit in the TSCR register. This write is not sufficient because the write is posted and therefore not guaranteed to immediately clear the bit. Due to that delay the CPU can raise the just handled interrupt again. Prevent this by reading the register back which causes the posted write to be flushed to the hardware before the read completes. Fixes: 3fed09559cd8 ("irqchip: Add RZ/G2L IA55 Interrupt Controller driver") Signed-off-by: Biju Das <biju.das.jz@bp.renesas.com> --- v1->v2: * Updated commit header and description. * Extended the flushing of posted write to IRQ interrupt aswell. --- drivers/irqchip/irq-renesas-rzg2l.c | 16 ++++++++++++++-- 1 file changed, 14 insertions(+), 2 deletions(-)