| Message ID | 20241115134401.3893008-7-claudiu.beznea.uj@bp.renesas.com (mailing list archive) |
|---|---|
| State | New |
| Delegated to: | Geert Uytterhoeven |
| Headers | show |
| Series | Add support for the rest of Renesas RZ/G3S serial interfaces | expand |
On Fri, Nov 15, 2024 at 03:43:59PM +0200, Claudiu wrote: > From: Claudiu Beznea <claudiu.beznea.uj@bp.renesas.com> > > There are different switches available on both the RZ/G3S SMARC Module and > RZ SMARC Carrier II boards. These switches are used to route different SoC > signals to different parts available on board. > > These switches are described in device trees through macros. These macros > are set accordingly such that the resulted compiled dtb to describe the > on-board switches states. > > Based on the SW_CONFIG3 switch state (populated on the module board), the > SCIF3 SoC interface is routed or not to an U(S)ART pin header available on > the carrier board. As the SCIF3 is accessible through the carrier board, > the device tree enables it in the carrier DTS. To be able to cope with > these type of configurations, add a header file where all the on-board > switches can be described and shared accordingly between module and carrier > board. > > Commit prepares the code to enable SCIF3 on the RZ/G3S carrier device > tree. > > Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@bp.renesas.com> > --- > > Changes in v3: > - none > > Changes in v2: > - none > > .../boot/dts/renesas/rzg3s-smarc-som.dtsi | 20 +----------- > .../boot/dts/renesas/rzg3s-smarc-switches.h | 32 +++++++++++++++++++ > 2 files changed, 33 insertions(+), 19 deletions(-) > create mode 100644 arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h > > diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi > index 55c72c8a0735..5c88e130c89e 100644 > --- a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi > +++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi > @@ -9,25 +9,7 @@ > #include <dt-bindings/gpio/gpio.h> > #include <dt-bindings/pinctrl/rzg2l-pinctrl.h> > > -/* > - * On-board switches' states: > - * @SW_OFF: switch's state is OFF > - * @SW_ON: switch's state is ON > - */ > -#define SW_OFF 0 > -#define SW_ON 1 > - > -/* > - * SW_CONFIG[x] switches' states: > - * @SW_CONFIG2: > - * SW_OFF - SD0 is connected to eMMC > - * SW_ON - SD0 is connected to uSD0 card > - * @SW_CONFIG3: > - * SW_OFF - SD2 is connected to SoC > - * SW_ON - SCIF1, SSI0, IRQ0, IRQ1 connected to SoC > - */ > -#define SW_CONFIG2 SW_OFF > -#define SW_CONFIG3 SW_ON > +#include "rzg3s-smarc-switches.h" > > / { > compatible = "renesas,rzg3s-smarcm", "renesas,r9a08g045s33", "renesas,r9a08g045"; > diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h b/arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h > new file mode 100644 > index 000000000000..e2d9b953f627 > --- /dev/null > +++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h > @@ -0,0 +1,32 @@ > +/* SPDX-License-Identifier: GPL-2.0 */ Use the same license as the .dtsi file. > +/* > + * On-board switches for the Renesas RZ/G3S SMARC Module and RZ SMARC Carrier II > + * boards. > + * > + * Copyright (C) 2024 Renesas Electronics Corp. > + */ > + > +#ifndef __RZG3S_SMARC_SWITCHES__ > +#define __RZG3S_SMARC_SWITCHES__ > + > +/* > + * On-board switches' states: > + * @SW_OFF: switch's state is OFF > + * @SW_ON: switch's state is ON > + */ > +#define SW_OFF 0 > +#define SW_ON 1 > + > +/* > + * SW_CONFIG[x] switches' states: > + * @SW_CONFIG2: > + * SW_OFF - SD0 is connected to eMMC > + * SW_ON - SD0 is connected to uSD0 card > + * @SW_CONFIG3: > + * SW_OFF - SD2 is connected to SoC > + * SW_ON - SCIF3, SSI3, IRQ0, IRQ1 connected to SoC > + */ > +#define SW_CONFIG2 SW_OFF > +#define SW_CONFIG3 SW_ON > + > +#endif /* __RZG3S_SMARC_SWITCHES__ */ > -- > 2.39.2 >
diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi index 55c72c8a0735..5c88e130c89e 100644 --- a/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi +++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc-som.dtsi @@ -9,25 +9,7 @@ #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/pinctrl/rzg2l-pinctrl.h> -/* - * On-board switches' states: - * @SW_OFF: switch's state is OFF - * @SW_ON: switch's state is ON - */ -#define SW_OFF 0 -#define SW_ON 1 - -/* - * SW_CONFIG[x] switches' states: - * @SW_CONFIG2: - * SW_OFF - SD0 is connected to eMMC - * SW_ON - SD0 is connected to uSD0 card - * @SW_CONFIG3: - * SW_OFF - SD2 is connected to SoC - * SW_ON - SCIF1, SSI0, IRQ0, IRQ1 connected to SoC - */ -#define SW_CONFIG2 SW_OFF -#define SW_CONFIG3 SW_ON +#include "rzg3s-smarc-switches.h" / { compatible = "renesas,rzg3s-smarcm", "renesas,r9a08g045s33", "renesas,r9a08g045"; diff --git a/arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h b/arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h new file mode 100644 index 000000000000..e2d9b953f627 --- /dev/null +++ b/arch/arm64/boot/dts/renesas/rzg3s-smarc-switches.h @@ -0,0 +1,32 @@ +/* SPDX-License-Identifier: GPL-2.0 */ +/* + * On-board switches for the Renesas RZ/G3S SMARC Module and RZ SMARC Carrier II + * boards. + * + * Copyright (C) 2024 Renesas Electronics Corp. + */ + +#ifndef __RZG3S_SMARC_SWITCHES__ +#define __RZG3S_SMARC_SWITCHES__ + +/* + * On-board switches' states: + * @SW_OFF: switch's state is OFF + * @SW_ON: switch's state is ON + */ +#define SW_OFF 0 +#define SW_ON 1 + +/* + * SW_CONFIG[x] switches' states: + * @SW_CONFIG2: + * SW_OFF - SD0 is connected to eMMC + * SW_ON - SD0 is connected to uSD0 card + * @SW_CONFIG3: + * SW_OFF - SD2 is connected to SoC + * SW_ON - SCIF3, SSI3, IRQ0, IRQ1 connected to SoC + */ +#define SW_CONFIG2 SW_OFF +#define SW_CONFIG3 SW_ON + +#endif /* __RZG3S_SMARC_SWITCHES__ */