@@ -17,7 +17,7 @@ void machine_kexec_mask_interrupts(void)
int check_eoi = 1;
chip = irq_desc_get_chip(desc);
- if (!chip)
+ if (!chip || !irqd_is_started(&desc->irq_data))
continue;
if (IS_ENABLED(CONFIG_GENERIC_IRQ_KEXEC_CLEAR_VM_FORWARD)) {
@@ -31,10 +31,6 @@ void machine_kexec_mask_interrupts(void)
if (check_eoi && chip->irq_eoi && irqd_irq_inprogress(&desc->irq_data))
chip->irq_eoi(&desc->irq_data);
- if (chip->irq_mask)
- chip->irq_mask(&desc->irq_data);
-
- if (chip->irq_disable && !irqd_irq_disabled(&desc->irq_data))
- chip->irq_disable(&desc->irq_data);
+ irq_shutdown(desc);
}
}
During machine kexec, the function machine_kexec_mask_interrupts() is responsible for disabling or masking all interrupts. While the irq_disable hook ensures that an already-disabled IRQ is not disabled again, the current implementation unconditionally invokes the irq_mask() function for every interrupt descriptor, even when the interrupt is already masked. A specific issue was observed in the crash kernel flow after unbinding a device (prior to kexec) that used a GPIO as an IRQ source. The warning was triggered by the gpiochip_disable_irq() function, which attempted to clear the FLAG_IRQ_IS_ENABLED flag when FLAG_USED_AS_IRQ was not set: ``` void gpiochip_disable_irq(struct gpio_chip *gc, unsigned int offset) { struct gpio_desc *desc = gpiochip_get_desc(gc, offset); if (!IS_ERR(desc) && !WARN_ON(!test_bit(FLAG_USED_AS_IRQ, &desc->flags))) clear_bit(FLAG_IRQ_IS_ENABLED, &desc->flags); } ``` This issue surfaced after commit a8173820f441 ("gpio: gpiolib: Allow GPIO IRQs to lazy disable") introduced lazy disablement for GPIO IRQs. It replaced disable/enable hooks with mask/unmask hooks. Unlike the disable hook, the mask hook doesn't handle already-masked IRQs. When a GPIO-IRQ driver is unbound, the IRQ is released, triggering __irq_disable() and irq_state_set_masked(). A subsequent call to machine_kexec_mask_interrupts() re-invokes chip->irq_mask(). This results in a call chain, including gpiochip_irq_mask() and gpiochip_disable_irq(). Since FLAG_USED_AS_IRQ was cleared earlier, a warning occurs. Replace calls to irq_mask() and irq_disable() hooks with a simplified call to irq_shutdown(), and check if the interrupt is started (irqd_is_started) before calling the shutdown. Signed-off-by: Eliav Farber <farbere@amazon.com> --- V5 -> V6: No changes. kernel/irq/kexec.c | 8 ++------ 1 file changed, 2 insertions(+), 6 deletions(-)