@@ -35,30 +35,31 @@
compatible = "gpio-leds";
user-led0 {
- label = "USER-LED0";
+ label = "hi3798cv200-poplar:green:user1";
gpios = <&gpio6 3 GPIO_ACTIVE_LOW>;
linux,default-trigger = "heartbeat";
default-state = "off";
};
user-led1 {
- label = "USER-LED1";
+ label = "hi3798cv200-poplar:green:user2";
gpios = <&gpio5 1 GPIO_ACTIVE_LOW>;
linux,default-trigger = "mmc0";
default-state = "off";
};
user-led2 {
- label = "USER-LED2";
+ label = "hi3798cv200-poplar:green:user3";
gpios = <&gpio5 2 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "none";
+ linux,default-trigger = "mmc1";
default-state = "off";
};
user-led3 {
- label = "USER-LED3";
+ label = "hi3798cv200-poplar:green:user4";
gpios = <&gpio10 6 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "cpu0";
+ linux,default-trigger = "none";
+ panic-indicator;
default-state = "off";
};
};
For all 96Boards, the following standard is used for onboard LEDs. device-name:green:user1 default-trigger: heartbeat device-name:green:user2 default-trigger: mmc0/disk-activity (onboard-storage) device-name:green:user3 default-trigger: mmc1 (SD-card) device-name:green:user4 default-trigger: none, panic-indicator device-name:yellow:wlan default-trigger: phy0tx device-name:blue:bt default-trigger: hci0-power So lets adopt the same for Poplar, which is one of the 96Boards Enterprise edition platform. Due to absence of WLAN and BT support, corresponding LED nodes are not considered. Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> --- .../arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts | 13 +++++++------ 1 file changed, 7 insertions(+), 6 deletions(-)