@@ -147,7 +147,7 @@ es8316-sound {
"Speaker", "Speaker Amplifier OUTL",
"Speaker", "Speaker Amplifier OUTR";
- simple-audio-card,hp-det-gpio = <&gpio0 RK_PB0 GPIO_ACTIVE_LOW>;
+ simple-audio-card,hp-det-gpio = <&gpio0 RK_PB0 GPIO_ACTIVE_HIGH>;
simple-audio-card,aux-devs = <&speaker_amp>;
simple-audio-card,pin-switches = "Speaker";
@@ -794,7 +794,7 @@ dc_det_gpio: dc-det-gpio {
es8316 {
hp_det_gpio: hp-det-gpio {
- rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_down>;
+ rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>;
};
};
On the Pinebook Pro the headphone jack is dual use. It can be used either as a normal headphone jack or as a debug serial connection. This functionality is controlled via a small hardware switch on the mainboard. Unfortunately flipping this switch biases the headphone detection switch inside the headphone jack at 3.3 V if in `debug UART` position but to GND when in `headphone out` position. This results in an inversion of the headphone detection logic depending on the switch position. Since the headphone jack can only be used for audio when in `headphone out` position this commit changes the headphone detect GPIO logic to be correct for that case rather than for the debug UART. Signed-off-by: Tobias Schramm <t.schramm@manjaro.org> --- arch/arm64/boot/dts/rockchip/rk3399-pinebook-pro.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)