@@ -326,7 +326,7 @@ &pcie2x1l0 {
&pcie2x1l2 {
pinctrl-names = "default";
- pinctrl-0 = <&pcie2_2_rst>;
+ pinctrl-0 = <&pcie20x12_pins>;
reset-gpios = <&gpio3 RK_PB0 GPIO_ACTIVE_HIGH>;
vpcie3v3-supply = <&vcc3v3_pcie2x1l2>;
status = "okay";
@@ -363,9 +363,15 @@ hp_detect: hp-detect {
};
};
- pcie2 {
- pcie2_2_rst: pcie2-2-rst {
- rockchip,pins = <3 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>;
+ pcie20x1 {
+ pcie20x12_pins: pcie20x12-pins {
+ rockchip,pins =
+ /* PCIE20_1_2_CLKREQn_M1_L */
+ <3 RK_PC7 RK_FUNC_GPIO &pcfg_pull_up>,
+ /* PCIE_PERST_L */
+ <3 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>,
+ /* PCIE20_1_2_WAKEn_M1_L */
+ <3 RK_PD0 RK_FUNC_GPIO &pcfg_pull_up>;
};
};
Add missing pinctrl settings for PCIe 2.0 x1 clock request and wake signals. Each component of PCIe communication have the following control signals: PERST, WAKE, CLKREQ, and REFCLK. These signals work to generate high-speed signals and communicate with other PCIe devices. Used by root complex to endpoint depending on the power state. PERST is referred to as a fundamental reset. PERST should be held low until all the power rails in the system and the reference clock are stable. A transition from low to high in this signal usually indicates the beginning of link initialization. WAKE signal is an active-low signal that is used to return the PCIe interface to an active state when in a low-power state. CLKREQ signal is also an active-low signal and is used to request the reference clock. Rename node from 'pcie2' to 'pcie20x1' to align with schematic nomenclature. Signed-off-by: Anand Moon <linux.amoon@gmail.com> --- v4: rebase on master, used RK_FUNC_GPIO GPIO function instead of PIN number. V3: New patch. --- arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts | 14 ++++++++++---- 1 file changed, 10 insertions(+), 4 deletions(-)