| Message ID | 1457921056-21257-7-git-send-email-cw00.choi@samsung.com (mailing list archive) |
|---|---|
| State | Superseded |
| Headers | show |
On 14.03.2016 11:04, Chanwoo Choi wrote: > From: Jaehoon Chung <jh80.chung@samsung.com> > > This patch adds MSHC (Mobile Storage Host Controller) dt node for Exynos3250 > SoC. MSHC is an interface between the system and the eMMC device. > > Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> > Signed-off-by: Andi Shyti <andi.shyti@samsung.com> > Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com> > --- > arch/arm/boot/dts/exynos3250-artik5.dtsi | 19 +++++++++++++++++++ > 1 file changed, 19 insertions(+) > > diff --git a/arch/arm/boot/dts/exynos3250-artik5.dtsi b/arch/arm/boot/dts/exynos3250-artik5.dtsi > index 97d0087efb9f..75b291c10cdc 100644 > --- a/arch/arm/boot/dts/exynos3250-artik5.dtsi > +++ b/arch/arm/boot/dts/exynos3250-artik5.dtsi > @@ -277,6 +277,25 @@ > }; > }; > > +&mshc_0 { > + num-slots = <1>; > + broken-cd; > + non-removable; Broken or non-removable, not both. > + cap-mmc-highspeed; > + desc-num = <4>; > + card-detect-delay = <200>; > + vmmc-supply = <&ldo11_reg>; Isn't this vqmmc-supply? BTW, both MMC0 regulators (ldo11, ldo12) are marked as always-on. Why they cannot be controlled by XMMC0CDN (just like on Rinato)? What is the benefit of making this patch separate from "Add exynos3250-artik5 dtsi file for ARTIK5 module"? Does the board boot properly without this patch? Best regards, Krzysztof > + clock-frequency = <100000000>; > + clock-freq-min-max = <400000 100000000>; > + samsung,dw-mshc-ciu-div = <1>; > + samsung,dw-mshc-sdr-timing = <0 1>; > + samsung,dw-mshc-ddr-timing = <1 2>; > + pinctrl-names = "default"; > + pinctrl-0 = <&sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8>; > + bus-width = <8>; > + status = "okay"; > +}; > + > &xusbxti { > clock-frequency = <24000000>; > }; > -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
On 2016? 03? 14? 15:57, Krzysztof Kozlowski wrote: > On 14.03.2016 11:04, Chanwoo Choi wrote: >> From: Jaehoon Chung <jh80.chung@samsung.com> >> >> This patch adds MSHC (Mobile Storage Host Controller) dt node for Exynos3250 >> SoC. MSHC is an interface between the system and the eMMC device. >> >> Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> >> Signed-off-by: Andi Shyti <andi.shyti@samsung.com> >> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com> >> --- >> arch/arm/boot/dts/exynos3250-artik5.dtsi | 19 +++++++++++++++++++ >> 1 file changed, 19 insertions(+) >> >> diff --git a/arch/arm/boot/dts/exynos3250-artik5.dtsi b/arch/arm/boot/dts/exynos3250-artik5.dtsi >> index 97d0087efb9f..75b291c10cdc 100644 >> --- a/arch/arm/boot/dts/exynos3250-artik5.dtsi >> +++ b/arch/arm/boot/dts/exynos3250-artik5.dtsi >> @@ -277,6 +277,25 @@ >> }; >> }; >> >> +&mshc_0 { >> + num-slots = <1>; >> + broken-cd; >> + non-removable; > > Broken or non-removable, not both. I'll remove the 'broken-cd' property. > >> + cap-mmc-highspeed; >> + desc-num = <4>; >> + card-detect-delay = <200>; >> + vmmc-supply = <&ldo11_reg>; > > Isn't this vqmmc-supply? I'll fix it as following by using ldo12_reg: vmmc-supply = <&ldo12_reg>; > > BTW, both MMC0 regulators (ldo11, ldo12) are marked as always-on. Why > they cannot be controlled by XMMC0CDN (just like on Rinato)? I'll fix it like rinato board to handle the ldo11/ldo12 as following: gpk0-2 is XMMC0CDN pin. ldo11_reg: LDO11 { - /* VDD_MMC */ + /* VDD74 ~ VDD75 */ regulator-name = "VLDO11_1.8V"; regulator-min-microvolt = <1800000>; regulator-max-microvolt = <1800000>; - regulator-always-on; + samsung,ext-control-gpios = <&gpk0 2 GPIO_ACTIVE_HIGH>; }; ldo12_reg: LDO12 { @@ -177,7 +178,7 @@ regulator-name = "VLDO12_2.8V"; regulator-min-microvolt = <2800000>; regulator-max-microvolt = <2800000>; - regulator-always-on; + samsung,ext-control-gpios = <&gpk0 2 GPIO_ACTIVE_HIGH>; }; > > What is the benefit of making this patch separate from "Add > exynos3250-artik5 dtsi file for ARTIK5 module"? Does the board boot > properly without this patch? OK. I'll merge it with 5/10 patch. Best Regards, Chanwoo Choi [snip] -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
On 14.03.2016 17:15, Chanwoo Choi wrote: > On 2016? 03? 14? 15:57, Krzysztof Kozlowski wrote: >> On 14.03.2016 11:04, Chanwoo Choi wrote: >>> From: Jaehoon Chung <jh80.chung@samsung.com> >>> >>> This patch adds MSHC (Mobile Storage Host Controller) dt node for Exynos3250 >>> SoC. MSHC is an interface between the system and the eMMC device. >>> >>> Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> >>> Signed-off-by: Andi Shyti <andi.shyti@samsung.com> >>> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com> >>> --- >>> arch/arm/boot/dts/exynos3250-artik5.dtsi | 19 +++++++++++++++++++ >>> 1 file changed, 19 insertions(+) >>> >>> diff --git a/arch/arm/boot/dts/exynos3250-artik5.dtsi b/arch/arm/boot/dts/exynos3250-artik5.dtsi >>> index 97d0087efb9f..75b291c10cdc 100644 >>> --- a/arch/arm/boot/dts/exynos3250-artik5.dtsi >>> +++ b/arch/arm/boot/dts/exynos3250-artik5.dtsi >>> @@ -277,6 +277,25 @@ >>> }; >>> }; >>> >>> +&mshc_0 { >>> + num-slots = <1>; >>> + broken-cd; >>> + non-removable; >> >> Broken or non-removable, not both. > > I'll remove the 'broken-cd' property. > >> >>> + cap-mmc-highspeed; >>> + desc-num = <4>; >>> + card-detect-delay = <200>; >>> + vmmc-supply = <&ldo11_reg>; >> >> Isn't this vqmmc-supply? > > I'll fix it as following by using ldo12_reg: > vmmc-supply = <&ldo12_reg>; Sure, looks good. > >> >> BTW, both MMC0 regulators (ldo11, ldo12) are marked as always-on. Why >> they cannot be controlled by XMMC0CDN (just like on Rinato)? > > I'll fix it like rinato board to handle the ldo11/ldo12 as following: > gpk0-2 is XMMC0CDN pin. Great! Thanks, Krzysztof -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/arch/arm/boot/dts/exynos3250-artik5.dtsi b/arch/arm/boot/dts/exynos3250-artik5.dtsi index 97d0087efb9f..75b291c10cdc 100644 --- a/arch/arm/boot/dts/exynos3250-artik5.dtsi +++ b/arch/arm/boot/dts/exynos3250-artik5.dtsi @@ -277,6 +277,25 @@ }; }; +&mshc_0 { + num-slots = <1>; + broken-cd; + non-removable; + cap-mmc-highspeed; + desc-num = <4>; + card-detect-delay = <200>; + vmmc-supply = <&ldo11_reg>; + clock-frequency = <100000000>; + clock-freq-min-max = <400000 100000000>; + samsung,dw-mshc-ciu-div = <1>; + samsung,dw-mshc-sdr-timing = <0 1>; + samsung,dw-mshc-ddr-timing = <1 2>; + pinctrl-names = "default"; + pinctrl-0 = <&sd0_cmd &sd0_bus1 &sd0_bus4 &sd0_bus8>; + bus-width = <8>; + status = "okay"; +}; + &xusbxti { clock-frequency = <24000000>; };