[V1,0/2] Refactor phy powerup sequence

Message

Nitin Rawat Jan. 12, 2024, 3:33 p.m. UTC

Refactor phy_power_on and phy_calibrate callbacks.

In Current code regulators enable, clks enable, calibrating UFS PHY,
start_serdes and polling PCS_ready_status are part of phy_power_on.

UFS PHY registers are retained after power collapse, meaning calibrating
UFS PHY, start_serdes and polling PCS_ready_status can be done only when
hba is powered_on, and not needed every time when phy_power_on is called
during resume. Hence keep the code which enables PHY's regulators & clks
in phy_power_on and move the rest steps into phy_calibrate function.

Since phy_power_on is separated out from phy calibrate, make separate calls
to phy_power_on and phy_calibrate calls from ufs qcom driver.

Also for better power saving, remove the phy_power_on/off calls from
resume/suspend path and put them to ufs_qcom_setup_clocks, so that
PHY's regulators & clks can be turned on/off along with UFS's clocks.

This patch series is tested on SM8550 MTP, SM8350 MTP and SA8775p.

There is functional dependency between ufs-qcom and phy-qcom-qmp-ufs
and hence both the patches should be part of same merge window.

Nitin Rawat (2):
  scsi: ufs: qcom : Refactor phy_power_on/off calls
  phy: qcom: Refactor phy_power_on and phy_calibrate callbacks

 drivers/phy/qualcomm/phy-qcom-qmp-ufs.c | 183 +++++++++---------------
 drivers/ufs/host/ufs-qcom.c             | 104 +++++++++-----
 drivers/ufs/host/ufs-qcom.h             |   4 +
 3 files changed, 139 insertions(+), 152 deletions(-)

--
2.43.0