@@ -401,11 +401,9 @@ static inline int ufshcd_get_lists_status(u32 reg)
* 1 UTRLRDY
* 2 UTMRLRDY
* 3 UCRDY
- * 4 HEI
- * 5 DEI
- * 6-7 reserved
+ * 4-7 reserved
*/
- return (((reg) & (0xFF)) >> 1) ^ (0x07);
+ return ((reg & 0xFF) >> 1) ^ 0x07;
}
/**
@@ -2726,7 +2724,7 @@ out:
* To bring UFS host controller to operational state,
* 1. Enable required interrupts
* 2. Configure interrupt aggregation
- * 3. Program UTRL and UTMRL base addres
+ * 3. Program UTRL and UTMRL base address
* 4. Configure run-stop-registers
*
* Returns 0 on success, non-zero value on failure
@@ -2756,8 +2754,13 @@ static int ufshcd_make_hba_operational(struct ufs_hba *hba)
REG_UTP_TASK_REQ_LIST_BASE_H);
/*
+ * Make sure base address and interrupt setup are updated before
+ * enabling the run/stop registers below.
+ */
+ wmb();
+
+ /*
* UCRDY, UTMRLDY and UTRLRDY bits must be 1
- * DEI, HEI bits must be 0
*/
reg = ufshcd_readl(hba, REG_CONTROLLER_STATUS);
if (!(ufshcd_get_lists_status(reg))) {
@@ -3920,7 +3923,13 @@ static int ufshcd_issue_tm_cmd(struct ufs_hba *hba, int lun_id, int task_id,
/* send command to the controller */
__set_bit(free_slot, &hba->outstanding_tasks);
+
+ /* Make sure descriptors are ready before ringing the task doorbell */
+ wmb();
+
ufshcd_writel(hba, 1 << free_slot, REG_UTP_TASK_REQ_DOOR_BELL);
+ /* Make sure that doorbell is committed immediately */
+ wmb();
spin_unlock_irqrestore(host->host_lock, flags);