@@ -286,6 +286,18 @@
#include <scsi/scsi_common.h>
#include <scsi/scsi_request.h>
+/*
+ * For the wait-and-retry loop after possibly having loaded the drive tray.
+ * 10 retries in 20 seconds are hardcoded in sr_do_ioctl() which was used
+ * up to 2008.
+ * But time spans up to 25 seconds were measured by libburn on
+ * drives connected via SATA or USB-SATA bridges.
+ * So 20 retries * 2000 ms = 40 seconds seems more appropriate.
+ */
+#define CD_OPEN_MEDIUM_RETRY_MAX 20
+#define CD_OPEN_MEDIUM_RETRY_MSLEEP 2000
+#include <linux/delay.h>
+
/* used to tell the module to turn on full debugging messages */
static bool debug;
/* default compatibility mode */
@@ -1040,6 +1052,114 @@ static void cdrom_count_tracks(struct cdrom_device_info *cdi, tracktype *tracks)
tracks->cdi, tracks->xa);
}
+static
+int wait_for_medium_decision(struct cdrom_device_info *cdi)
+{
+ int retry = 0, ret;
+ const struct cdrom_device_ops *cdo = cdi->ops;
+
+ /* Wait until the intermediate drive status CDS_DRIVE_NOT_READY ends */
+ while (1) {
+ ret = cdo->drive_status(cdi, CDSL_CURRENT);
+ if (ret == CDS_DRIVE_NOT_READY &&
+ retry++ < CD_OPEN_MEDIUM_RETRY_MAX)
+ msleep(CD_OPEN_MEDIUM_RETRY_MSLEEP);
+ else
+ break;
+ }
+ if (ret != CDS_DISC_OK)
+ return ret;
+ /*
+ * It is hard to test whether very recent readiness can cause race
+ * conditions with media change events. So wait a while to never
+ * undercut the average delay between actual readiness and detection
+ * which was tested without this additional msleep().
+ */
+ msleep(CD_OPEN_MEDIUM_RETRY_MSLEEP / 2);
+
+ return CDS_DISC_OK;
+}
+
+/*
+ * To be called by expectant callers of cdrom_open(), before they call
+ * check_disk_change() and then cdrom_open().
+ *
+ * If the mode is right, the drive capable, the tray out, and autoclose
+ * enabled, try to move in the tray and wait for the drive's decision about
+ * the medium.
+ * Return 0 if cdrom_open() would not want to know the tray status, or the
+ * drive cannot report its tray status at all, or the decision is CDS_DISC_OK.
+ * Else return a negative error number.
+ * Input parameter mode decides whether cdrom_open() will want to know or
+ * change the tray status at all.
+ * Input parameter leave_open == 1 suppresses the try to close and the waiting
+ * for a decision. It rather just assesses the situation. Submit mode == 0
+ * to not hamper assessment.
+ */
+int cdrom_handle_open_tray(struct cdrom_device_info *cdi, fmode_t mode,
+ int leave_open)
+{
+ int ret;
+ const struct cdrom_device_ops *cdo = cdi->ops;
+
+ if ((mode & FMODE_NDELAY) && (cdi->options & CDO_USE_FFLAGS))
+ return 0;
+ if (!cdo->drive_status)
+ return 0;
+
+ ret = cdo->drive_status(cdi, CDSL_CURRENT);
+ cd_dbg(CD_OPEN, "drive_status=%d\n", ret);
+ if (ret == CDS_DRIVE_NOT_READY) {
+ /* Probably some other entity is loading the tray */
+ if (leave_open)
+ return -ENOMEDIUM;
+ wait_for_medium_decision(cdi);
+ goto assess_and_return;
+ }
+ if (ret != CDS_TRAY_OPEN)
+ goto assess_and_return;
+
+ cd_dbg(CD_OPEN, "the tray is open...\n");
+ if (leave_open)
+ return -ENOMEDIUM;
+ /* can/may i close it? */
+ if (CDROM_CAN(CDC_CLOSE_TRAY) && cdi->options & CDO_AUTO_CLOSE) {
+ cd_dbg(CD_OPEN, "trying to close the tray\n");
+ ret = cdo->tray_move(cdi, 0);
+ if (ret) {
+ cd_dbg(CD_OPEN,
+ "bummer. tried to close the tray but failed.\n");
+ /* Ignore the error from the low
+ * level driver. We don't care why it
+ * couldn't close the tray. We only care
+ * that there is no disc in the drive,
+ * since that is the _REAL_ problem here.
+ */
+ return -ENOMEDIUM;
+ }
+ } else {
+ if (!CDROM_CAN(CDC_CLOSE_TRAY))
+ cd_dbg(CD_OPEN,
+ "bummer. this drive can't close the tray.\n");
+ return -ENOMEDIUM;
+ }
+
+ ret = wait_for_medium_decision(cdi);
+ if (ret == CDS_NO_DISC || ret == CDS_TRAY_OPEN) {
+ cd_dbg(CD_OPEN, "bummer. the tray is still not closed.\n");
+ cd_dbg(CD_OPEN, "tray might not contain a medium\n");
+ return -ENOMEDIUM;
+ }
+ cd_dbg(CD_OPEN, "the tray is now closed\n");
+
+assess_and_return:
+ ret = cdo->drive_status(cdi, CDSL_CURRENT);
+ if (ret != CDS_DISC_OK)
+ return -ENOMEDIUM;
+ return 0;
+}
+EXPORT_SYMBOL(cdrom_handle_open_tray);
+
static
int open_for_data(struct cdrom_device_info *cdi)
{
@@ -1047,50 +1167,15 @@ int open_for_data(struct cdrom_device_info *cdi)
const struct cdrom_device_ops *cdo = cdi->ops;
tracktype tracks;
cd_dbg(CD_OPEN, "entering open_for_data\n");
- /* Check if the driver can report drive status. If it can, we
- can do clever things. If it can't, well, we at least tried! */
- if (cdo->drive_status != NULL) {
- ret = cdo->drive_status(cdi, CDSL_CURRENT);
- cd_dbg(CD_OPEN, "drive_status=%d\n", ret);
- if (ret == CDS_TRAY_OPEN) {
- cd_dbg(CD_OPEN, "the tray is open...\n");
- /* can/may i close it? */
- if (CDROM_CAN(CDC_CLOSE_TRAY) &&
- cdi->options & CDO_AUTO_CLOSE) {
- cd_dbg(CD_OPEN, "trying to close the tray\n");
- ret=cdo->tray_move(cdi,0);
- if (ret) {
- cd_dbg(CD_OPEN, "bummer. tried to close the tray but failed.\n");
- /* Ignore the error from the low
- level driver. We don't care why it
- couldn't close the tray. We only care
- that there is no disc in the drive,
- since that is the _REAL_ problem here.*/
- ret=-ENOMEDIUM;
- goto clean_up_and_return;
- }
- } else {
- cd_dbg(CD_OPEN, "bummer. this drive can't close the tray.\n");
- ret=-ENOMEDIUM;
- goto clean_up_and_return;
- }
- /* Ok, the door should be closed now.. Check again */
- ret = cdo->drive_status(cdi, CDSL_CURRENT);
- if ((ret == CDS_NO_DISC) || (ret==CDS_TRAY_OPEN)) {
- cd_dbg(CD_OPEN, "bummer. the tray is still not closed.\n");
- cd_dbg(CD_OPEN, "tray might not contain a medium\n");
- ret=-ENOMEDIUM;
- goto clean_up_and_return;
- }
- cd_dbg(CD_OPEN, "the tray is now closed\n");
- }
- /* the door should be closed now, check for the disc */
- ret = cdo->drive_status(cdi, CDSL_CURRENT);
- if (ret!=CDS_DISC_OK) {
- ret = -ENOMEDIUM;
- goto clean_up_and_return;
- }
- }
+
+ /*
+ * Check for open tray, but do not close it. The caller should
+ * have cared to call cdrom_handle_open_tray(,,0) in advance.
+ */
+ ret = cdrom_handle_open_tray(cdi, (fmode_t)0, 1);
+ if (ret)
+ goto clean_up_and_return;
+
cdrom_count_tracks(cdi, &tracks);
if (tracks.error == CDS_NO_DISC) {
cd_dbg(CD_OPEN, "bummer. no disc.\n");
@@ -98,6 +98,9 @@ int cdrom_multisession(struct cdrom_device_info *cdi,
int cdrom_read_tocentry(struct cdrom_device_info *cdi,
struct cdrom_tocentry *entry);
+int cdrom_handle_open_tray(struct cdrom_device_info *cdi, fmode_t mode,
+ int leave_open);
+
/* the general block_device operations structure: */
extern int cdrom_open(struct cdrom_device_info *cdi, struct block_device *bdev,
fmode_t mode);
If open("/dev/sr0", O_RDONLY); pulls in the tray of an optical drive, it immediately returns -1 with errno ENOMEDIUM or the first read(2) fails with EIO. Later, when the drive has stopped blinking, another open() yields success and read() works. This affects not only userland reading of the device file but also mounting the device. Since commit 210ba1d1724f ("[SCSI] sr: update to follow tray status correctly") of january 2008 the necessary waiting loop after emitting the tray loading command is not performed, because sr_do_ioctl() is not called any more. Commit 2bbea6e11735 ("cdrom: do not call check_disk_change() inside cdrom_open()") of march 2008 moved medium assessment out of cdrom_open() and thus inevitable before automatic tray loading. Factor out a new function cdrom_handle_open_tray() in cdrom.c from open_for_data() and export it, so that callers of cdrom_open() can call it before their call of check_disk_change(). It decides whether it can and should load the tray. If so, it emits the tray loading command and waits for the drive to make its decision. Replace automatic tray loading in cdrom_open() by a mere check whether the drive reports a usable medium in a loaded tray. Unaware callers of cdrom_open() will not cause automatic tray loading any more, but rather will reliably see -ENOMEDIUM if the tray is open. Signed-off-by: Thomas Schmitt <scdbackup@gmx.net> --- drivers/cdrom/cdrom.c | 173 +++++++++++++++++++++++++++++++----------- include/linux/cdrom.h | 3 + 2 files changed, 132 insertions(+), 44 deletions(-) -- 2.20.1