@@ -615,8 +615,6 @@
&pci0 {
status = "okay";
- pinctrl-0 = <&usb0_pins>;
- pinctrl-names = "default";
};
&pci1 {
@@ -627,13 +625,14 @@
&hsusb {
status = "okay";
- pinctrl-0 = <&usb0_pins>;
- pinctrl-names = "default";
- renesas,enable-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
};
&usbphy {
status = "okay";
+ renesas,pwr-gpio = <&gpio2 4 GPIO_ACTIVE_HIGH>;
+ renesas,id-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
+ renesas,vbus-gpio = <&gpio7 24 GPIO_ACTIVE_HIGH>;
+ renesas,vbus-pwr-gpio = <&gpio7 23 GPIO_ACTIVE_HIGH>;
};
&pcie_bus_clk {
Both USB Host (pci0) and Function (USBHS) drivers are enabled. The USB PHY driver determines which IP block should be connected based on vbus and id signals read via gpios. Note that switch SW5 and SW6 on Koelsch board needs to be set to position 3 for this to work. Signed-off-by: Phil Edworthy <phil.edworthy@renesas.com> --- Not for upstream until the following patches have been accepted: "usb: renesas_usbhs: Allow an OTG PHY driver to provide VBUS" "phy: rcar-gen2 usb: Add Host/Function switching for USB0" Hence, not signed off. v4: - Changed prefix in title. v3: - Remove "pinctrl-names" as well as "pinctrl-0" props. v2: - Added -gpio to dts prop names of GPIO pins. --- arch/arm/boot/dts/r8a7791-koelsch.dts | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-)