| Message ID | 201107130040.02752.rjw@sisk.pl (mailing list archive) |
|---|---|
| State | Superseded |
| Headers | show |
On Wed, Jul 13, 2011 at 7:40 AM, Rafael J. Wysocki <rjw@sisk.pl> wrote: > From: Rafael J. Wysocki <rjw@sisk.pl> > > Instead of coding the undocumented dependencies between power domains > A3RV and A4LC on SH7372 directly into the low-level power up/down > routines, make A3RV be a subdomain of A4LC, which will cause the > same dependecies to hold. > > Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl> > --- Thanks for your effort of cleaning up the code! You are correct that putting A3RV as a subdomain of A4LC will help with one side of the problem. The not so visible problem at this point is the connection between A4R and A3RV. A4R is a power domain which contains some I/O devices and the two power domains A3RV and A3RI. Because of the hardware dependency between A4R and A3RV we would need to force A4R to be powered on whenever A3RV is being used. So A4R is the "real" parent pm domain from the data sheet point of view. To simplify the software side one option could be to make A4LC the parent of A3RV and A4R the parent of A4LC. This is not however a very good fit either - the hardware allows us to have A4LC powered on without A4R or A3RV. This case is quite common and happens when any LCD panel is enabled but the rest of the system is idle. For the case when no A4R support is in place your suggestion is fine. But to support A4R we need to deal with something similar to what my patch does anyway. It is worth nothing that A4R contains an interrupt controller and needs special care that way too. Also the I/O devices in A4R require QoS software to be in place before we can start powering down A4R for real. So the reason behind my somewhat ugly existing A3RV and A4LC power domain code is to make sure the framework code can do whatever we need to do for A4R support. Or perhaps it can be done in a better way? Any ideas? Thanks, / magnus -- To unsubscribe from this list: send the line "unsubscribe linux-sh" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
Index: linux-2.6/arch/arm/mach-shmobile/pm-sh7372.c =================================================================== --- linux-2.6.orig/arch/arm/mach-shmobile/pm-sh7372.c +++ linux-2.6/arch/arm/mach-shmobile/pm-sh7372.c @@ -91,36 +91,6 @@ static int pd_power_up(struct generic_pm return ret; } -static int pd_power_up_a3rv(struct generic_pm_domain *genpd) -{ - int ret = pd_power_up(genpd); - - /* force A4LC on after A3RV has been requested on */ - pm_genpd_poweron(&sh7372_a4lc.genpd); - - return ret; -} - -static int pd_power_down_a3rv(struct generic_pm_domain *genpd) -{ - int ret = pd_power_down(genpd); - - /* try to power down A4LC after A3RV is requested off */ - pm_genpd_poweron(&sh7372_a4lc.genpd); - queue_work(pm_wq, &sh7372_a4lc.genpd.power_off_work); - - return ret; -} - -static int pd_power_down_a4lc(struct generic_pm_domain *genpd) -{ - /* only power down A4LC if A3RV is off */ - if (!(__raw_readl(PSTR) & (1 << sh7372_a3rv.bit_shift))) - return pd_power_down(genpd); - - return 0; -} - static bool pd_active_wakeup(struct device *dev) { return true; @@ -134,17 +104,8 @@ void sh7372_init_pm_domain(struct sh7372 genpd->stop_device = pm_clk_suspend; genpd->start_device = pm_clk_resume; genpd->active_wakeup = pd_active_wakeup; - - if (sh7372_pd == &sh7372_a4lc) { - genpd->power_off = pd_power_down_a4lc; - genpd->power_on = pd_power_up; - } else if (sh7372_pd == &sh7372_a3rv) { - genpd->power_off = pd_power_down_a3rv; - genpd->power_on = pd_power_up_a3rv; - } else { - genpd->power_off = pd_power_down; - genpd->power_on = pd_power_up; - } + genpd->power_off = pd_power_down; + genpd->power_on = pd_power_up; genpd->power_on(&sh7372_pd->genpd); } Index: linux-2.6/arch/arm/mach-shmobile/setup-sh7372.c =================================================================== --- linux-2.6.orig/arch/arm/mach-shmobile/setup-sh7372.c +++ linux-2.6/arch/arm/mach-shmobile/setup-sh7372.c @@ -30,6 +30,7 @@ #include <linux/sh_dma.h> #include <linux/sh_intc.h> #include <linux/sh_timer.h> +#include <linux/pm_domain.h> #include <mach/hardware.h> #include <mach/sh7372.h> #include <asm/mach-types.h> @@ -848,6 +849,8 @@ void __init sh7372_add_standard_devices( sh7372_init_pm_domain(&sh7372_a3ri); sh7372_init_pm_domain(&sh7372_a3sg); + pm_genpd_add_subdomain(&sh7372_a4lc.genpd, &sh7372_a3sg.genpd); + platform_add_devices(sh7372_early_devices, ARRAY_SIZE(sh7372_early_devices));