@@ -544,6 +544,7 @@ static int usbhsf_pio_try_push(struct usbhs_pkt *pkt, int *is_done)
usbhsf_send_terminator(pipe, fifo);
usbhsf_tx_irq_ctrl(pipe, !*is_done);
+ usbhs_pipe_running(pipe, !*is_done);
usbhs_pipe_enable(pipe);
dev_dbg(dev, " send %d (%d/ %d/ %d/ %d)\n",
@@ -570,12 +571,21 @@ usbhs_fifo_write_busy:
* retry in interrupt
*/
usbhsf_tx_irq_ctrl(pipe, 1);
+ usbhs_pipe_running(pipe, 1);
return ret;
}
+static int usbhsf_pio_prepare_push(struct usbhs_pkt *pkt, int *is_done)
+{
+ if (usbhs_pipe_is_running(pkt->pipe))
+ return 0;
+
+ return usbhsf_pio_try_push(pkt, is_done);
+}
+
struct usbhs_pkt_handle usbhs_fifo_pio_push_handler = {
- .prepare = usbhsf_pio_try_push,
+ .prepare = usbhsf_pio_prepare_push,
.try_run = usbhsf_pio_try_push,
};
@@ -589,6 +599,9 @@ static int usbhsf_prepare_pop(struct usbhs_pkt *pkt, int *is_done)
if (usbhs_pipe_is_busy(pipe))
return 0;
+ if (usbhs_pipe_is_running(pipe))
+ return 0;
+
/*
* pipe enable to prepare packet receive
*/
@@ -597,6 +610,7 @@ static int usbhsf_prepare_pop(struct usbhs_pkt *pkt, int *is_done)
usbhs_pipe_set_trans_count_if_bulk(pipe, pkt->length);
usbhs_pipe_enable(pipe);
+ usbhs_pipe_running(pipe, 1);
usbhsf_rx_irq_ctrl(pipe, 1);
return 0;
@@ -642,6 +656,7 @@ static int usbhsf_pio_try_pop(struct usbhs_pkt *pkt, int *is_done)
(total_len < maxp)) { /* short packet */
*is_done = 1;
usbhsf_rx_irq_ctrl(pipe, 0);
+ usbhs_pipe_running(pipe, 0);
usbhs_pipe_disable(pipe); /* disable pipe first */
}
@@ -805,6 +820,7 @@ static void xfer_work(struct work_struct *work)
dev_dbg(dev, " %s %d (%d/ %d)\n",
fifo->name, usbhs_pipe_number(pipe), pkt->length, pkt->zero);
+ usbhs_pipe_running(pipe, 1);
usbhs_pipe_set_trans_count_if_bulk(pipe, pkt->trans);
usbhs_pipe_enable(pipe);
usbhsf_dma_start(pipe, fifo);
@@ -836,6 +852,10 @@ static int usbhsf_dma_prepare_push(struct usbhs_pkt *pkt, int *is_done)
if ((uintptr_t)(pkt->buf + pkt->actual) & 0x7) /* 8byte alignment */
goto usbhsf_pio_prepare_push;
+ /* return at this time if the pipe is running */
+ if (usbhs_pipe_is_running(pipe))
+ return 0;
+
/* get enable DMA fifo */
fifo = usbhsf_get_dma_fifo(priv, pkt);
if (!fifo)
@@ -873,6 +893,7 @@ static int usbhsf_dma_push_done(struct usbhs_pkt *pkt, int *is_done)
pkt->actual = pkt->trans;
*is_done = !pkt->zero; /* send zero packet ? */
+ usbhs_pipe_running(pipe, !*is_done);
usbhsf_dma_stop(pipe, pipe->fifo);
usbhsf_dma_unmap(pkt);
@@ -972,8 +993,10 @@ static int usbhsf_dma_pop_done(struct usbhs_pkt *pkt, int *is_done)
if ((pkt->actual == pkt->length) || /* receive all data */
(pkt->trans < maxp)) { /* short packet */
*is_done = 1;
+ usbhs_pipe_running(pipe, 0);
} else {
/* re-enable */
+ usbhs_pipe_running(pipe, 0);
usbhsf_prepare_pop(pkt, is_done);
}
@@ -578,6 +578,19 @@ int usbhs_pipe_is_dir_host(struct usbhs_pipe *pipe)
return usbhsp_flags_has(pipe, IS_DIR_HOST);
}
+int usbhs_pipe_is_running(struct usbhs_pipe *pipe)
+{
+ return usbhsp_flags_has(pipe, IS_RUNNING);
+}
+
+void usbhs_pipe_running(struct usbhs_pipe *pipe, int running)
+{
+ if (running)
+ usbhsp_flags_set(pipe, IS_RUNNING);
+ else
+ usbhsp_flags_clr(pipe, IS_RUNNING);
+}
+
void usbhs_pipe_data_sequence(struct usbhs_pipe *pipe, int sequence)
{
u16 mask = (SQCLR | SQSET);
@@ -36,6 +36,7 @@ struct usbhs_pipe {
#define USBHS_PIPE_FLAGS_IS_USED (1 << 0)
#define USBHS_PIPE_FLAGS_IS_DIR_IN (1 << 1)
#define USBHS_PIPE_FLAGS_IS_DIR_HOST (1 << 2)
+#define USBHS_PIPE_FLAGS_IS_RUNNING (1 << 3)
struct usbhs_pkt_handle *handler;
@@ -80,6 +81,9 @@ int usbhs_pipe_probe(struct usbhs_priv *priv);
void usbhs_pipe_remove(struct usbhs_priv *priv);
int usbhs_pipe_is_dir_in(struct usbhs_pipe *pipe);
int usbhs_pipe_is_dir_host(struct usbhs_pipe *pipe);
+int usbhs_pipe_is_running(struct usbhs_pipe *pipe);
+void usbhs_pipe_running(struct usbhs_pipe *pipe, int running);
+
void usbhs_pipe_init(struct usbhs_priv *priv,
int (*dma_map_ctrl)(struct usbhs_pkt *pkt, int map));
int usbhs_pipe_get_maxpacket(struct usbhs_pipe *pipe);
Some gadget drivers will call usb_ep_queue() more than once before the first queue doesn't finish. However, this driver didn't handle it correctly. So, this patch fixes the behavior of some usbhs_pkt_handle using the "running" flag. Otherwise, the oops below happens if we use g_ncm driver and when the "iperf -u -c host -b 200M" is running. Unable to handle kernel NULL pointer dereference at virtual address 00000000 pgd = c0004000 [00000000] *pgd=00000000 Internal error: Oops: 80000007 [#1] SMP ARM Modules linked in: usb_f_ncm g_ncm libcomposite u_ether CPU: 0 PID: 0 Comm: swapper/0 Tainted: G W 3.17.0-rc1-00008-g8b2be8a-dirty #20 task: c051c7e0 ti: c0512000 task.ti: c0512000 PC is at 0x0 LR is at usbhsf_pkt_handler+0xa8/0x114 pc : [<00000000>] lr : [<c0278fb4>] psr: 60000193 sp : c0513ce8 ip : c0513c58 fp : c0513d24 r10: 00000001 r9 : 00000193 r8 : eebec4a0 r7 : eebec410 r6 : eebe0c6c r5 : 00000000 r4 : ee4a2774 r3 : 00000000 r2 : ee251e00 r1 : c0513cf4 r0 : ee4a2774 Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com> --- drivers/usb/renesas_usbhs/fifo.c | 25 ++++++++++++++++++++++++- drivers/usb/renesas_usbhs/pipe.c | 13 +++++++++++++ drivers/usb/renesas_usbhs/pipe.h | 4 ++++ 3 files changed, 41 insertions(+), 1 deletion(-)