@@ -31,11 +31,15 @@
#include <linux/i2c/tsc2007.h>
#include <linux/io.h>
#include <linux/smsc911x.h>
+#include <linux/sh_intc.h>
+#include <linux/sh_clk.h>
#include <linux/gpio.h>
#include <linux/input.h>
#include <linux/input/sh_keysc.h>
#include <linux/usb/r8a66597.h>
+#include <sound/sh_fsi.h>
+
#include <video/sh_mobile_lcdc.h>
#include <video/sh_mipi_dsi.h>
@@ -112,6 +116,13 @@
* S39: bit2: off
*/
+/*
+ * FSI/FSMI
+ *
+ * SW41 : ON : SH-Mobile AP4 Audio Mode
+ * : OFF : Bluetooth Audio Mode
+ */
+
/* MTD */
static struct mtd_partition nor_flash_partitions[] = {
{
@@ -364,6 +375,60 @@ static struct platform_device mipidsi0_device = {
},
};
+/* FSI */
+#define IRQ_FSI evt2irq(0x1840)
+#define FSIACKCR 0xE6150018
+static void fsiackcr_init(struct clk *clk)
+{
+ u32 status = __raw_readl(clk->enable_reg);
+
+ /* use external clock */
+ status &= ~0x000000ff;
+ status |= 0x00000080;
+ __raw_writel(status, clk->enable_reg);
+}
+
+static struct clk_ops fsiackcr_clk_ops = {
+ .init = fsiackcr_init,
+};
+
+static struct clk fsiackcr_clk = {
+ .ops = &fsiackcr_clk_ops,
+ .enable_reg = (void __iomem *)FSIACKCR,
+ .rate = 0, /* unknown */
+};
+
+struct sh_fsi_platform_info fsi_info = {
+ .porta_flags = SH_FSI_BRS_INV |
+ SH_FSI_OUT_SLAVE_MODE |
+ SH_FSI_IN_SLAVE_MODE |
+ SH_FSI_OFMT(PCM) |
+ SH_FSI_IFMT(PCM),
+};
+
+static struct resource fsi_resources[] = {
+ [0] = {
+ .name = "FSI",
+ .start = 0xFE3C0000,
+ .end = 0xFE3C0400 - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = IRQ_FSI,
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static struct platform_device fsi_device = {
+ .name = "sh_fsi2",
+ .id = 0,
+ .num_resources = ARRAY_SIZE(fsi_resources),
+ .resource = fsi_resources,
+ .dev = {
+ .platform_data = &fsi_info,
+ },
+};
+
static struct platform_device *ap4evb_devices[] __initdata = {
&nor_flash_device,
&smc911x_device,
@@ -372,6 +437,7 @@ static struct platform_device *ap4evb_devices[] __initdata = {
&usb1_host_device,
&lcdc_device,
&mipidsi0_device,
+ &fsi_device,
};
/* TouchScreen (Needs SW3 set to OFF) */
@@ -382,6 +448,12 @@ struct tsc2007_platform_data tsc2007_info = {
};
/* I2C */
+static struct i2c_board_info i2c0_devices[] = {
+ {
+ I2C_BOARD_INFO("ak4643", 0x13),
+ },
+};
+
static struct i2c_board_info i2c1_devices[] = {
{
I2C_BOARD_INFO("r2025sd", 0x32),
@@ -454,8 +526,27 @@ eclkdsitxget:
device_initcall(ap4evb_init_display_clk);
+/*
+ * FIXME !!
+ *
+ * gpio_no_direction is quick_hack.
+ *
+ * current gpio frame work doesn't have
+ * the method to control only pull up/down/free.
+ * this function should be replaced by correct gpio function
+ */
+static void __init gpio_no_direction(u32 addr)
+{
+ __raw_writeb(0x00, addr);
+}
+
+#define GPIO_PORT9CR 0xE6051009
+#define GPIO_PORT10CR 0xE605100A
+
static void __init ap4evb_init(void)
{
+ struct clk *clk;
+
sh7372_pinmux_init();
/* enable SCIFA0 */
@@ -520,9 +611,6 @@ static void __init ap4evb_init(void)
gpio_request(GPIO_FN_IRQ28_123, NULL);
set_irq_type(IRQ28, IRQ_TYPE_LEVEL_LOW);
- i2c_register_board_info(1, i2c1_devices,
- ARRAY_SIZE(i2c1_devices));
-
/* USB enable */
gpio_request(GPIO_FN_VBUS0_1, NULL);
gpio_request(GPIO_FN_IDIN_1_18, NULL);
@@ -534,6 +622,47 @@ static void __init ap4evb_init(void)
/* setup USB phy */
__raw_writew(0x8a0a, 0xE6058130); /* USBCR2 */
+ /* enable FSI2 */
+ gpio_request(GPIO_FN_FSIAIBT, NULL);
+ gpio_request(GPIO_FN_FSIAILR, NULL);
+ gpio_request(GPIO_FN_FSIAISLD, NULL);
+ gpio_request(GPIO_FN_FSIAOSLD, NULL);
+ gpio_request(GPIO_PORT161, NULL);
+ gpio_direction_output(GPIO_PORT161, 0); /* slave */
+
+ gpio_request(GPIO_PORT9, NULL);
+ gpio_request(GPIO_PORT10, NULL);
+ gpio_no_direction(GPIO_PORT9CR); /* FSIAOBT needs no direction */
+ gpio_no_direction(GPIO_PORT10CR); /* FSIAOLR needs no direction */
+
+ /* set SPU2 clock to 119.6 MHz */
+ clk = clk_get(NULL, "spu_clk");
+ if (!IS_ERR_VALUE(clk)) {
+ clk_set_rate(clk, clk_round_rate(clk, 119600000));
+ clk_put(clk);
+ }
+
+ /* change parent of FSI A */
+ clk = clk_get(NULL, "fsia_clk");
+ if (!IS_ERR_VALUE(clk)) {
+ clk_register(&fsiackcr_clk);
+ clk_set_parent(clk, &fsiackcr_clk);
+ clk_put(clk);
+ }
+
+ /*
+ * set irq priority, to avoid sound chopping
+ * when NFS rootfs is used
+ * FSI(3) > SMSC911X(2)
+ */
+ intc_set_priority(IRQ_FSI, 3);
+
+ i2c_register_board_info(0, i2c0_devices,
+ ARRAY_SIZE(i2c0_devices));
+
+ i2c_register_board_info(1, i2c1_devices,
+ ARRAY_SIZE(i2c1_devices));
+
sh7372_add_standard_devices();
platform_add_devices(ap4evb_devices, ARRAY_SIZE(ap4evb_devices));
@@ -246,7 +246,7 @@ enum { MSTP001,
MSTP106, MSTP101, MSTP100,
MSTP223,
MSTP207, MSTP206, MSTP204, MSTP203, MSTP202, MSTP201, MSTP200,
- MSTP329, MSTP323, MSTP322, MSTP314, MSTP313,
+ MSTP329, MSTP328, MSTP323, MSTP322, MSTP314, MSTP313,
MSTP415, MSTP410, MSTP411, MSTP406, MSTP403,
MSTP_NR };
@@ -274,6 +274,7 @@ static struct clk mstp_clks[MSTP_NR] = {
[MSTP201] = MSTP(&div6_clks[DIV6_SUB], SMSTPCR2, 1, 0), /* SCIFA3 */
[MSTP200] = MSTP(&div6_clks[DIV6_SUB], SMSTPCR2, 0, 0), /* SCIFA4 */
[MSTP329] = MSTP(&r_clk, SMSTPCR3, 29, 0), /* CMT10 */
+ [MSTP328] = MSTP(&div6_clks[DIV6_SPU], SMSTPCR3, 28, CLK_ENABLE_ON_INIT), /* FSIA */
[MSTP323] = MSTP(&div6_clks[DIV6_SUB], SMSTPCR3, 23, 0), /* IIC1 */
[MSTP322] = MSTP(&div6_clks[DIV6_SUB], SMSTPCR3, 22, 0), /* USB0 */
[MSTP314] = MSTP(&div4_clks[DIV4_HP], SMSTPCR3, 14, 0), /* SDHI0 */
@@ -356,6 +357,7 @@ static struct clk_lookup lookups[] = {
CLKDEV_DEV_ID("sh-sci.3", &mstp_clks[MSTP201]), /* SCIFA3 */
CLKDEV_DEV_ID("sh-sci.4", &mstp_clks[MSTP200]), /* SCIFA4 */
CLKDEV_CON_ID("cmt1", &mstp_clks[MSTP329]), /* CMT10 */
+ CLKDEV_DEV_ID("sh_fsi", &mstp_clks[MSTP328]), /* FSI */
CLKDEV_DEV_ID("i2c-sh_mobile.1", &mstp_clks[MSTP323]), /* IIC1 */
CLKDEV_DEV_ID("r8a66597_hcd.0", &mstp_clks[MSTP323]), /* USB0 */
CLKDEV_DEV_ID("r8a66597_udc.0", &mstp_clks[MSTP323]), /* USB0 */