@@ -57,24 +57,6 @@ tablet_mode {
linux,code = <SW_TABLET_MODE>;
wakeup-source;
};
-
- microphone_insert {
- label = "Microphone Plug";
- gpios = <&gpio 96 GPIO_ACTIVE_HIGH>;
- linux,input-type = <EV_SW>;
- linux,code = <SW_MICROPHONE_INSERT>;
- debounce-interval = <100>;
- wakeup-source;
- };
-
- headphone_insert {
- label = "Headphone Plug";
- gpios = <&gpio 97 GPIO_ACTIVE_HIGH>;
- linux,input-type = <EV_SW>;
- linux,code = <SW_HEADPHONE_INSERT>;
- debounce-interval = <100>;
- wakeup-source;
- };
};
i2c {
@@ -123,6 +105,18 @@ wlan_pwrseq: pwrseq0 {
reset-gpios = <&gpio 58 GPIO_ACTIVE_HIGH>;
};
+ sound-card {
+ compatible = "audio-graph-card";
+ label = "OLPC XO";
+ dais = <&sspa0_dai>;
+ routing = "Headphones", "HPOL",
+ "Headphones", "HPOR",
+ "MIC2", "Mic Jack";
+ widgets = "Headphone", "Headphones", "Microphone", "Mic Jack";
+ hp-det-gpio = <&gpio 97 GPIO_ACTIVE_HIGH>;
+ mic-det-gpio = <&gpio 96 GPIO_ACTIVE_HIGH>;
+ };
+
soc {
axi@d4200000 {
ap-sp@d4290000 {
@@ -197,6 +191,14 @@ audio-codec@1a {
compatible = "realtek,alc5631";
reg = <0x1a>;
status = "okay";
+
+ port {
+ rt5631_0: endpoint {
+ mclk-fs = <256>;
+ clocks = <&audio_clk 0>;
+ remote-endpoint = <&sspa0_0>;
+ };
+ };
};
};
@@ -243,3 +245,30 @@ camera0_0: endpoint {
};
};
};
+
+&asram {
+ status = "okay";
+};
+
+&adma0 {
+ status = "okay";
+};
+
+&audio_clk {
+ status = "okay";
+};
+
+&sspa0 {
+ status = "okay";
+ dmas = <&adma0 0>, <&adma0 1>;
+ dma-names = "tx", "rx";
+
+ sspa0_dai: port {
+ sspa0_0: endpoint {
+ remote-endpoint = <&rt5631_0>;
+ frame-master;
+ bitclock-master;
+ dai-format = "i2s";
+ };
+ };
+};
This enables the audio SRAM, DMA engine, I2S interface, and codec, hooks them together and adds a audio-graph-card instance. It also removes the jack gpios from the gpio-keys instance, because the audio jack driver registers an input device. Signed-off-by: Lubomir Rintel <lkundrak@v3.sk> --- arch/arm/boot/dts/mmp2-olpc-xo-1-75.dts | 65 ++++++++++++++++++------- 1 file changed, 47 insertions(+), 18 deletions(-)