mbox series

[v3,0/3] usb: Add quirk for writing high-low order

Message ID 1718019553-111939-1-git-send-email-dh10.jung@samsung.com (mailing list archive)
Headers show
Series usb: Add quirk for writing high-low order | expand

Message

Jung Daehwan June 10, 2024, 11:39 a.m. UTC 
There's the limitation of Synopsys dwc3 controller with ERST programming in
supporting separate ERSTBA_HI and ERSTBA_LO programming. It's supported when
the ERSTBA is programmed ERSTBA_HI before ERSTBA_LO. But, writing operations
in xHCI is done low-high order following xHCI spec. xHCI specification 5.1
"Register Conventions" states that 64 bit registers should be written in
low-high order. Synopsys dwc3 needs workaround for high-low order. That's why
I add new quirk to support this.

---
Changes in v3:
- remove dt-bindings of dwc3/xhci
- pass quirk property unconditionally from dwc3 to xhci platform
- add description and change note in each patch
Link to v2: https://lore.kernel.org/r/1717135657-120818-1-git-send-email-dh10.jung@samsung.com/

Changes in v2:
- add a quirk in dwc3
- add dt-bindings of dwc3/xhci
- set the quirk in xhci-plat from dwc3
Link to v1: https://lore.kernel.org/r/1716875836-186791-1-git-send-email-dh10.jung@samsung.com/

Changes in v1:
- add a quirk in xhci
- use the quirk for programming ERST high-low order
Link to RFC: https://lore.kernel.org/r/1716339839-44022-1-git-send-email-dh10.jung@samsung.com/
---

Daehwan Jung (3):
  usb: dwc3: Support quirk for writing high-low order
  xhci: Add a quirk for writing ERST in high-low order
  usb: host: xhci-plat: Add support for XHCI_WRITE_64_HI_LO

 drivers/usb/dwc3/host.c      | 4 +++-
 drivers/usb/host/xhci-mem.c  | 5 ++++-
 drivers/usb/host/xhci-plat.c | 3 +++
 drivers/usb/host/xhci.h      | 2 ++
 4 files changed, 12 insertions(+), 2 deletions(-)