[0/5] Fix controller halt and endxfer timeout issues

Message

Wesley Cheng July 8, 2022, 6:50 p.m. UTC

This patch series addresses some issues seen while testing with the latest
soft disconnect implementation where EP events are allowed to process while
the controller halt is occurring.

#1
Since routines can now interweave, we can see that the soft disconnect can
occur while conndone is being serviced.  This leads to a controller halt
timeout, as the soft disconnect clears the DEP flags, for which conndone
interrupt handler will issue a __dwc3_ep_enable(ep0), that leads to
re-issuing the set ep config command for every endpoint.

#2
Function drivers can ask for a delayed_status phase, while it processes the
received SETUP packet.  This can lead to large delays when handling the
soft disconnect routine.  To improve the timing, forcefully send the status
phase, as we are going to disconnect from the host.

#3
Ensure that local interrupts are left enabled, so that EP0 events can be
processed while the soft disconnect/dequeue is happening.

#4
Modify the DWC3_EP_DELAY_STOP flag management so that if these flags were set
before soft disconnect, that the disconnect routine will be able to properly
issue the endxfer command.

#5
Since EP0 events can occur during controller halt, it may increase the time
needed for the controller to fully stop.

Wesley Cheng (5):
  usb: dwc3: Do not service EP0 and conndone events if soft disconnected
  usb: dwc3: gadget: Force sending delayed status during soft disconnect
  usb: dwc3: gadget: Adjust IRQ management during soft
    disconnect/connect
  usb: dwc3: Allow end transfer commands to be sent during soft
    disconnect
  usb: dwc3: gadget: Increase DWC3 controller halt timeout

 drivers/usb/dwc3/ep0.c    |  9 +++++----
 drivers/usb/dwc3/gadget.c | 31 ++++++++++++++++++++++---------
 2 files changed, 27 insertions(+), 13 deletions(-)