[v7,0/1] usb: serial: add support for CH348

Message

Corentin LABBE May 7, 2024, 1:15 p.m. UTC

Hello

The CH348 is an octo serial to USB adapter.
The following patch adds a driver for supporting it.
Since there is no public datasheet, unfortunatly it remains some magic values.

It was tested with a large range of baud from 1200 to 1500000 and used with
success in one of our kernel CI testlab.

Regards

Changes since v1:
- use a data structure for encoding/decoding messages.
- check if needed endpoints exists
- fix URB leak in ch348_allocate_status_read error case
- test for maximum baud rate as stated by datasheet

Changes since v2:
- specify ch348_rxbuf data length
- Use correct speed_t dwDTERate instead of __le32
- test for maximum baud rate supported according to datasheet
- Use a define for CH348_TX_HDRSIZE

Changes since v3
- Fixed all reported problem from https://lore.kernel.org/lkml/Y5NDwEakGJbmB6+b@Red/T/#mb6234d0427cfdabf412190565e215995a41482dd
  Mostly reworked the endpoint mux to be the same than mx_uport

Changes since v4:
- The V4 was sent against stable and next have ch348_set_termios ktermios
  parameter const that I forgot to change

Changes since v5:
- Fixed all reported problem from https://lore.kernel.org/lkml/[e-mail]/T/#m044aab24dfb652ea34aa06f8ef704da9d6a2e036
- Major change is dropping of all status handling which was unused.
  It will be probably necessary to bring it back when using GPIO.
  This will be done when I will finish my next devboard.

Changes since v6:
- read and print the device version during probe
- Only request one bulk out channel from usb-serial core
- Implement status report / interrupt handling
- Fix buffer->rate calculation / enable support for slow baud rates
- use a mutex to protect against concurrent writes
- split write buffers for slow baud rates

Important note, v7 is mostly done from work of Martin Blumenstingl,
so the changelog was built from https://github.com/xdarklight/ch348/commits/main/
Great thanks to him

Corentin Labbe (1):
  usb: serial: add support for CH348

 drivers/usb/serial/Kconfig  |   9 +
 drivers/usb/serial/Makefile |   1 +
 drivers/usb/serial/ch348.c  | 725 ++++++++++++++++++++++++++++++++++++
 3 files changed, 735 insertions(+)
 create mode 100644 drivers/usb/serial/ch348.c