[v2,1/2] dt-bindings: usb: add documentation for typec switch via GPIO

Commit Message

Jun Li March 1, 2019, 1:25 a.m. UTC

Some typec super speed active channel switch can be controlled via
a GPIO, this binding can be used to specify the switch node by
a GPIO and the remote endpoint of its consumre.

Signed-off-by: Li Jun <[e-mail]>
---
No change on v2 for this patch.

 .../devicetree/bindings/usb/typec-switch-gpio.txt  | 30 ++++++++++++++++++++++
 1 file changed, 30 insertions(+)

Patch

diff --git a/Documentation/devicetree/bindings/usb/typec-switch-gpio.txt b/Documentation/devicetree/bindings/usb/typec-switch-gpio.txt
new file mode 100644
index 0000000..4ef76cf
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/typec-switch-gpio.txt
@@ -0,0 +1,30 @@ 
+Typec orientation switch via a GPIO
+-----------------------------------
+
+Required properties:
+- compatible: should be set one of following:
+	- "nxp,ptn36043" for NXP Type-C SuperSpeed active switch.
+
+- gpios: the GPIO used to switch the super speed active channel,
+		GPIO_ACTIVE_HIGH: GPIO state high for cc1;
+		GPIO_ACTIVE_LOW:  GPIO state low for cc1.
+- orientation-switch: must be present.
+
+Required sub-node:
+- port: specify the remote endpoint of typec switch consumer.
+
+Example:
+
+ptn36043 {
+	compatible = "nxp,ptn36043";
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_ss_sel>;
+	gpios = <&gpio3 15 GPIO_ACTIVE_HIGH>;
+	orientation-switch;
+
+	port {
+		usb3_data_ss: endpoint {
+			remote-endpoint = <&typec_con_ss>;
+		};
+	};
+};