@@ -27,7 +27,9 @@ Optional properties:
- ranges : allows valid 1:1 translation between child's address space and
parent's address space
- extcon : external connector for vbus and idpin changes detection, needed
- when supports dual-role mode.
+ when supports dual-role mode; it's consiedered valid for compatibility
+ reasons, and not allowed for new bindings, use the property
+ usb-role-switch instead.
- vbus-supply : reference to the VBUS regulator, needed when supports
dual-role mode.
- pinctrl-names : a pinctrl state named "default" is optional, and need be
@@ -36,7 +38,8 @@ Optional properties:
is not set.
- pinctrl-0 : pin control group
See: Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
-
+ - usb-role-switch : use USB Role Switch to support dual-role switch, but
+ not extcon
- maximum-speed : valid arguments are "super-speed", "high-speed" and
"full-speed"; refer to usb/generic.txt
- enable-manual-drd : supports manual dual-role switch via debugfs; usually
@@ -61,6 +64,9 @@ The xhci should be added as subnode to mtu3 as shown in the following example
if host mode is enabled. The DT binding details of xhci can be found in:
Documentation/devicetree/bindings/usb/mediatek,mtk-xhci.txt
+The port would be added as subnode if use usb-role-switch property
+ see graph.txt
+
Example:
ssusb: usb@11271000 {
compatible = "mediatek,mt8173-mtu3";
Now the USB Role Switch is supported, so add properties about it Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com> --- v3: no changes v2 changes: 1. fix typo 2. refer new binding about connector property --- .../devicetree/bindings/usb/mediatek,mtu3.txt | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-)