@@ -35,7 +35,7 @@
/*
* Maximum size of ep0 response buffer for ch9 requests,
* the set_sel request uses 6 so far, the max.
-*/
+ */
#define EP0_RESPONSE_BUFF 6
/* Start with SS as default */
#define EP0_MAX_PKT_SIZE 512
@@ -68,7 +68,7 @@ static void ep_bd_list_free(struct bdc_ep *ep, u32 num_tabs)
* check if the bd_table struct is allocated ?
* if yes, then check if bd memory has been allocated, then
* free the dma_pool and also the bd_table struct memory
- */
+ */
bd_table = bd_list->bd_table_array[index];
dev_dbg(bdc->dev, "bd_table:%p index:%d\n", bd_table, index);
if (!bd_table) {
@@ -164,7 +164,7 @@ static void bdc_func_wake_timer(struct work_struct *work)
/*
* Check if host has started transferring on endpoints
* FUNC_WAKE_ISSUED is cleared when transfer has started after resume
- */
+ */
if (bdc->devstatus & FUNC_WAKE_ISSUED) {
dev_dbg(bdc->dev, "FUNC_WAKE_ISSUED FLAG IS STILL SET\n");
/* flag is still set, so again send func wake */
@@ -205,7 +205,7 @@ static void handle_link_state_change(struct bdc *bdc, u32 uspc)
* if not then send function wake again every
* TNotification secs until host initiates
* transfer to BDC, USB3 spec Table 8.13
- */
+ */
schedule_delayed_work(
&bdc->func_wake_notify,
msecs_to_jiffies(BDC_TNOTIFY));
@@ -379,7 +379,7 @@ static int bdc_udc_start(struct usb_gadget *gadget,
* Run the controller from here and when BDC is connected to
* Host then driver will receive a USPC SR with VBUS present
* and then driver will do a softconnect.
- */
+ */
ret = bdc_run(bdc);
if (ret) {
dev_err(bdc->dev, "%s bdc run fail\n", __func__);
fix the warning: WARNING:BLOCK_COMMENT_STYLE: Block comments should align the * on each line Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com> --- drivers/usb/gadget/udc/bdc/bdc.h | 2 +- drivers/usb/gadget/udc/bdc/bdc_ep.c | 2 +- drivers/usb/gadget/udc/bdc/bdc_udc.c | 6 +++--- 3 files changed, 5 insertions(+), 5 deletions(-)