@@ -5544,6 +5544,12 @@ void xhci_init_driver(struct hc_driver *drv,
drv->check_bandwidth = over->check_bandwidth;
if (over->reset_bandwidth)
drv->reset_bandwidth = over->reset_bandwidth;
+ if (over->address_device)
+ drv->address_device = over->address_device;
+ if (over->bus_suspend)
+ drv->bus_suspend = over->bus_suspend;
+ if (over->bus_resume)
+ drv->bus_resume = over->bus_resume;
}
}
EXPORT_SYMBOL_GPL(xhci_init_driver);
@@ -1947,6 +1947,9 @@ struct xhci_driver_overrides {
struct usb_host_endpoint *ep);
int (*check_bandwidth)(struct usb_hcd *, struct usb_device *);
void (*reset_bandwidth)(struct usb_hcd *, struct usb_device *);
+ int (*address_device)(struct usb_hcd *hcd, struct usb_device *udev);
+ int (*bus_suspend)(struct usb_hcd *hcd);
+ int (*bus_resume)(struct usb_hcd *hcd);
};
#define XHCI_CFC_DELAY 10
@@ -2103,6 +2106,7 @@ int xhci_drop_endpoint(struct usb_hcd *hcd, struct usb_device *udev,
struct usb_host_endpoint *ep);
int xhci_check_bandwidth(struct usb_hcd *hcd, struct usb_device *udev);
void xhci_reset_bandwidth(struct usb_hcd *hcd, struct usb_device *udev);
+int xhci_address_device(struct usb_hcd *hcd, struct usb_device *udev);
int xhci_disable_slot(struct xhci_hcd *xhci, u32 slot_id);
int xhci_ext_cap_init(struct xhci_hcd *xhci);
Co-processor needs some information about connected usb device. It's proper to pass information after usb device gets address when getting "Set Address" command. It supports vendors to implement it using xhci overrides. There're several power scenarios depending on vendors. It gives vendors flexibilty to meet their power requirement. They can override suspend and resume of root hub. Signed-off-by: Daehwan Jung <dh10.jung@samsung.com> --- drivers/usb/host/xhci.c | 6 ++++++ drivers/usb/host/xhci.h | 4 ++++ 2 files changed, 10 insertions(+)