@@ -149,9 +149,17 @@ static int rsi_find_bulk_in_and_out_endpoints(struct usb_interface *interface,
break;
}
- if (!(dev->bulkin_endpoint_addr[0]) &&
- dev->bulkout_endpoint_addr[0])
+ if (!(dev->bulkin_endpoint_addr[0] && dev->bulkout_endpoint_addr[0])) {
+ dev_err(&interface->dev, "missing wlan bulk endpoints\n");
return -EINVAL;
+ }
+
+ if (adapter->priv->coex_mode > 1) {
+ if (!dev->bulkin_endpoint_addr[1]) {
+ dev_err(&interface->dev, "missing bt bulk-in endpoint\n");
+ return -EINVAL;
+ }
+ }
return 0;
}
The driver expects at least one bulk-in endpoint when in "wifi-alone" operating mode and two bulk-in endpoints otherwise, and would otherwise fail to to submit the corresponding bulk URB to the default pipe during probe with a somewhat cryptic message: rsi_91x: rsi_rx_urb_submit: Failed in urb submission rsi_91x: rsi_probe: Failed in probe...Exiting RSI-USB WLAN: probe of 2-2.4:1.0 failed with error -8 The current endpoint sanity check looks broken and would only bail out early if there was no bulk-in endpoint but at least one bulk-out endpoint. Tighten this check to always require at least one bulk-in and one bulk-out endpoint, and add the missing sanity check for a Bluetooth bulk-in endpoint when in a BT operating mode. Also make sure to log an informative error message when the expected endpoints are missing. Signed-off-by: Johan Hovold <johan@kernel.org> --- drivers/net/wireless/rsi/rsi_91x_usb.c | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-)