@@ -719,4 +719,5 @@ void mtu3_gadget_reset(struct mtu3 *mtu)
mtu->u1_enable = 0;
mtu->u2_enable = 0;
mtu->delayed_status = false;
+ mtu->test_mode = false;
}
@@ -7,6 +7,7 @@
* Author: Chunfeng.Yun <chunfeng.yun@mediatek.com>
*/
+#include <linux/iopoll.h>
#include <linux/usb/composite.h>
#include "mtu3.h"
@@ -263,6 +264,7 @@ static int handle_test_mode(struct mtu3 *mtu, struct usb_ctrlrequest *setup)
{
void __iomem *mbase = mtu->mac_base;
int handled = 1;
+ u32 value;
switch (le16_to_cpu(setup->wIndex) >> 8) {
case TEST_J:
@@ -292,6 +294,14 @@ static int handle_test_mode(struct mtu3 *mtu, struct usb_ctrlrequest *setup)
if (mtu->test_mode_nr == TEST_PACKET_MODE)
ep0_load_test_packet(mtu);
+ /* send status before entering test mode. */
+ value = mtu3_readl(mbase, U3D_EP0CSR) & EP0_W1C_BITS;
+ mtu3_writel(mbase, U3D_EP0CSR, value | EP0_SETUPPKTRDY | EP0_DATAEND);
+
+ /* wait for ACK status sent by host, ignore timeout error */
+ readl_poll_timeout_atomic(mbase + U3D_EP0CSR, value,
+ !(value & EP0_DATAEND), 100, 5000);
+
mtu3_writel(mbase, U3D_USB2_TEST_MODE, mtu->test_mode_nr);
mtu->ep0_state = MU3D_EP0_STATE_SETUP;
There is an error dialog popped up in PC when test TEST_J/K by EHSETT tool, due to not waiting for the completion of control transfer. Here fix it by entering test mode after Status Stage finish. Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com> --- v2: 1. reset test_mode as default value when controller is reset 2. use readl_poll_timeout_atomic() --- drivers/usb/mtu3/mtu3_gadget.c | 1 + drivers/usb/mtu3/mtu3_gadget_ep0.c | 10 ++++++++++ 2 files changed, 11 insertions(+)