| Message ID | 1248877744-7273-1-git-send-email-me@bobcopeland.com (mailing list archive) |
|---|---|
| State | Accepted, archived |
| Headers | show |
diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c index 7db32ce..55ee976 100644 --- a/drivers/net/wireless/ath/ath5k/base.c +++ b/drivers/net/wireless/ath/ath5k/base.c @@ -1117,6 +1117,8 @@ ath5k_mode_setup(struct ath5k_softc *sc) struct ath5k_hw *ah = sc->ah; u32 rfilt; + ah->ah_op_mode = sc->opmode; + /* configure rx filter */ rfilt = sc->filter_flags; ath5k_hw_set_rx_filter(ah, rfilt); @@ -2768,6 +2770,7 @@ static int ath5k_add_interface(struct ieee80211_hw *hw, } ath5k_hw_set_lladdr(sc->ah, conf->mac_addr); + ath5k_mode_setup(sc); ret = 0; end:
Previously, we would store the operating mode at interface up time, but only update the PCU registers when the next reset happened. The result is that if beacon configuration (ops->bss_info_changed) happens before ops->config, we will program the wrong things into the timer registers. Consequently, beacons won't work in AP mode until after a reset (channel change, scan etc.). This is fragile anyway so just program the opmode as soon as mac80211 gives it to us. Signed-off-by: Bob Copeland <me@bobcopeland.com> --- drivers/net/wireless/ath/ath5k/base.c | 3 +++ 1 files changed, 3 insertions(+), 0 deletions(-)