@@ -78,6 +78,20 @@
allwinner,drive = <0>;
allwinner,pull = <2>;
};
+
+ bt_pwr_pin: bt_pwr_pin@0 {
+ allwinner,pins = "PH18";
+ allwinner,function = "gpio_out";
+ allwinner,drive = <0>;
+ allwinner,pull = <0>;
+ };
+
+ bt_wake_pin: bt_wake_pin@0 {
+ allwinner,pins = "PH24";
+ allwinner,function = "gpio_out";
+ allwinner,drive = <0>;
+ allwinner,pull = <0>;
+ };
};
uart0: serial@01c28000 {
@@ -86,6 +100,12 @@
status = "okay";
};
+ uart2: serial@01c28800 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart2_pins_a>;
+ status = "okay";
+ };
+
gmac: ethernet@01c50000 {
pinctrl-names = "default";
pinctrl-0 = <&gmac_pins_rgmii>;
@@ -157,4 +177,21 @@
gpio = <&pio 7 3 0>;
};
};
+
+ rfkill-switches {
+ compatible = "simple-bus";
+ pinctrl-names = "default";
+
+ rfkill_bt {
+ compatible = "rfkill-gpio";
+ pinctrl-names = "default";
+ pinctrl-0 = <&bt_pwr_pin>, <&clk_out_a_pins>;
+ rfkill-name = "bt";
+ rfkill-type = <2>;
+ bt_shutdown-gpios = <0>, <&pio 7 18 0>; /* PH18 */
+ bt_reset-gpios = <&pio 7 24 0>; /* PH24 */
+ clocks = <&clk_out_a>;
+ clock-frequency = <32768>;
+ };
+ };
};
The CubieTruck has an AMPAK AP6210 WiFi+Bluetooth module. The Bluetooth part is a BCM20710 device connected to UART2 in the A20 SoC. The IC also requires a 32.768 KHz low power clock input for proper auto-detection of the main clock, and power enable and wake signals via GPIO. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 37 ++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+)