| Message ID | 1439480454-31214-1-git-send-email-vthiagar@qti.qualcomm.com (mailing list archive) |
|---|---|
| State | Not Applicable |
| Delegated to: | Kalle Valo |
| Headers | show |
Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com> writes: > WMI 10.4 uses the same command interface as QCA988X for addba/delba > debug wmi commands. Fill wmi_10_4_ops table with the functions used > for QCA988X for these commands. > > With this change, the following debugfs entries can be used to > configure the aggregation mode and to send addba request, > addba response and delba respectively in manual aggregation mode > for QCA99X0 chip. > > /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode > /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba > /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp > /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba > > Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com> Thanks, applied.
diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c index 36b8f71..9769936 100644 --- a/drivers/net/wireless/ath/ath10k/wmi.c +++ b/drivers/net/wireless/ath/ath10k/wmi.c @@ -6482,6 +6482,10 @@ static const struct wmi_ops wmi_10_4_ops = { .gen_pktlog_enable = ath10k_wmi_op_gen_pktlog_enable, .gen_pktlog_disable = ath10k_wmi_op_gen_pktlog_disable, .gen_pdev_set_quiet_mode = ath10k_wmi_op_gen_pdev_set_quiet_mode, + .gen_addba_clear_resp = ath10k_wmi_op_gen_addba_clear_resp, + .gen_addba_send = ath10k_wmi_op_gen_addba_send, + .gen_addba_set_resp = ath10k_wmi_op_gen_addba_set_resp, + .gen_delba_send = ath10k_wmi_op_gen_delba_send, /* shared with 10.2 */ .gen_peer_assoc = ath10k_wmi_10_2_op_gen_peer_assoc,
WMI 10.4 uses the same command interface as QCA988X for addba/delba debug wmi commands. Fill wmi_10_4_ops table with the functions used for QCA988X for these commands. With this change, the following debugfs entries can be used to configure the aggregation mode and to send addba request, addba response and delba respectively in manual aggregation mode for QCA99X0 chip. /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com> --- drivers/net/wireless/ath/ath10k/wmi.c | 4 ++++ 1 file changed, 4 insertions(+)