@@ -31,28 +31,6 @@ config WILC1000_SPI
immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to
VDDIO. Select this if your platform is using the SPI bus.
-choice
- prompt "WILC1000 Memory Allocation"
- depends on WILC1000
- default WILC1000_PREALLOCATE_AT_LOADING_DRIVER
-
-config WILC1000_PREALLOCATE_AT_LOADING_DRIVER
- bool "Preallocate memory at loading driver"
- ---help---
- This choice supports static allocation of the memory
- for the receive buffer. The driver will allocate the RX buffer
- during initial time. The driver will also free the buffer
- by calling network device stop.
-
-config WILC1000_DYNAMICALLY_ALLOCATE_MEMROY
- bool "Dynamically allocate memory in real time"
- ---help---
- This choice supports dynamic allocation of the memory
- for the receive buffer. The driver will allocate the RX buffer
- when it is required.
-endchoice
-
-
config WILC1000_HW_OOB_INTR
bool "WILC1000 out of band interrupt"
depends on WILC1000_SDIO
@@ -7,12 +7,6 @@ ccflags-y += -DSTA_FIRMWARE=\"atmel/wilc1000_fw.bin\" \
ccflags-y += -I$(src)/ -D__CHECK_ENDIAN__ -DWILC_ASIC_A0 -DWILC_DEBUGFS
#ccflags-y += -DTCP_ACK_FILTER
-ccflags-$(CONFIG_WILC1000_PREALLOCATE_AT_LOADING_DRIVER) += -DMEMORY_STATIC \
- -DWILC_PREALLOC_AT_INSMOD
-
-ccflags-$(CONFIG_WILC1000_DYNAMICALLY_ALLOCATE_MEMROY) += -DWILC_NORMAL_ALLOC
-
-
wilc1000-objs := wilc_wfi_cfgoperations.o linux_wlan.o linux_mon.o \
wilc_msgqueue.o \
coreconfigurator.o host_interface.o \
@@ -124,9 +124,7 @@ extern atomic_t WILC_DEBUG_LEVEL;
#define FN_IN /* PRINT_D(">>> \n") */
#define FN_OUT /* PRINT_D("<<<\n") */
-#ifdef MEMORY_STATIC
#define LINUX_RX_SIZE (96 * 1024)
-#endif
#define LINUX_TX_SIZE (64 * 1024)
@@ -12,10 +12,8 @@ typedef struct {
u32 cfg_frame_offset;
int cfg_seq_no;
- #ifdef MEMORY_STATIC
u8 *rx_buffer;
u32 rx_buffer_offset;
- #endif
u8 *tx_buffer;
u32 tx_buffer_offset;
@@ -1050,9 +1048,6 @@ static void wilc_wlan_handle_rxq(struct wilc *wilc)
if (offset >= size)
break;
} while (1);
-#ifndef MEMORY_STATIC
- kfree(buffer);
-#endif
kfree(rqe);
if (has_packet)
@@ -1097,9 +1092,7 @@ static void wilc_sleeptimer_isr_ext(struct wilc *wilc, u32 int_stats1)
static void wilc_wlan_handle_isr_ext(struct wilc *wilc, u32 int_status)
{
wilc_wlan_dev_t *p = &g_wlan;
-#ifdef MEMORY_STATIC
u32 offset = p->rx_buffer_offset;
-#endif
u8 *buffer = NULL;
u32 size;
u32 retries = 0;
@@ -1118,7 +1111,6 @@ static void wilc_wlan_handle_isr_ext(struct wilc *wilc, u32 int_status)
}
if (size > 0) {
-#ifdef MEMORY_STATIC
if (LINUX_RX_SIZE - offset < size)
offset = 0;
@@ -1129,13 +1121,6 @@ static void wilc_wlan_handle_isr_ext(struct wilc *wilc, u32 int_status)
goto _end_;
}
-#else
- buffer = kmalloc(size, GFP_KERNEL);
- if (!buffer) {
- usleep_range(100 * 1000, 100 * 1000);
- goto _end_;
- }
-#endif
p->hif_func.hif_clear_int_ext(wilc,
DATA_INT_CLR | ENABLE_RX_VMM);
ret = p->hif_func.hif_block_rx_ext(wilc, 0, buffer, size);
@@ -1146,10 +1131,8 @@ static void wilc_wlan_handle_isr_ext(struct wilc *wilc, u32 int_status)
}
_end_:
if (ret) {
-#ifdef MEMORY_STATIC
offset += size;
p->rx_buffer_offset = offset;
-#endif
rqe = kmalloc(sizeof(*rqe), GFP_KERNEL);
if (rqe) {
rqe->buffer = buffer;
@@ -1157,10 +1140,6 @@ _end_:
PRINT_D(RX_DBG, "rxq entery Size= %d - Address = %p\n", rqe->buffer_size, rqe->buffer);
wilc_wlan_rxq_add(wilc, rqe);
}
- } else {
-#ifndef MEMORY_STATIC
- kfree(buffer);
-#endif
}
}
wilc_wlan_handle_rxq(wilc);
@@ -1442,16 +1421,11 @@ void wilc_wlan_cleanup(struct net_device *dev)
rqe = wilc_wlan_rxq_remove(wilc);
if (!rqe)
break;
-#ifndef MEMORY_STATIC
- kfree(rqe->buffer);
-#endif
kfree(rqe);
} while (1);
- #ifdef MEMORY_STATIC
kfree(p->rx_buffer);
p->rx_buffer = NULL;
- #endif
kfree(p->tx_buffer);
acquire_bus(wilc, ACQUIRE_AND_WAKEUP);
@@ -1691,7 +1665,6 @@ int wilc_wlan_init(struct net_device *dev)
goto _fail_;
}
-#if defined(MEMORY_STATIC)
if (!g_wlan.rx_buffer)
g_wlan.rx_buffer = kmalloc(LINUX_RX_SIZE, GFP_KERNEL);
PRINT_D(TX_DBG, "g_wlan.rx_buffer =%p\n", g_wlan.rx_buffer);
@@ -1700,7 +1673,6 @@ int wilc_wlan_init(struct net_device *dev)
PRINT_ER("Can't allocate Rx Buffer");
goto _fail_;
}
-#endif
if (!init_chip(dev)) {
ret = -EIO;
@@ -1714,10 +1686,8 @@ int wilc_wlan_init(struct net_device *dev)
_fail_:
- #ifdef MEMORY_STATIC
kfree(g_wlan.rx_buffer);
g_wlan.rx_buffer = NULL;
- #endif
kfree(g_wlan.tx_buffer);
g_wlan.tx_buffer = NULL;
This patch remove memory allocation options in Kconfig. It was used a long time ago to aquire memory, which we will not use this config anymore. Remove it's config, related define and codes as well. We will take PREALLOCATE_AT_LOADING_DRIVER as it is default. Signed-off-by: Glen Lee <glen.lee@atmel.com> --- drivers/staging/wilc1000/Kconfig | 22 -------------------- drivers/staging/wilc1000/Makefile | 6 ------ drivers/staging/wilc1000/linux_wlan_common.h | 2 -- drivers/staging/wilc1000/wilc_wlan.c | 30 ---------------------------- 4 files changed, 60 deletions(-)