| Message ID | 1456929832-6147-1-git-send-email-rmanohar@qti.qualcomm.com (mailing list archive) |
|---|---|
| State | Not Applicable |
| Delegated to: | Kalle Valo |
| Headers | show |
Rajkumar Manoharan <rmanohar@qti.qualcomm.com> writes: > commit 166de3f1895d ("ath10k: remove supported chain mask") had revealed > an issue on monitor mode. Configuring NSS upon monitor interface > creation is causing target assert in all qca9888x and qca6174 firmware. > Firmware assert issue can be reproduced by below sequence even after > reverting commit 166de3f1895d ("ath10k: remove supported chain mask"). > > ip link set wlan0 down > iw wlan0 set type monitor > iw phy0 set antenna 7 > ip link set wlan0 up > > This issue is originally reported on qca9888 with 10.1 firmware. > > Fixes: 5572a95b4b ("ath10k: apply chainmask settings to vdev on creation") > Reported-by: Janusz Dziedzic <janusz.dziedzic@tieto.com> > Signed-off-by: Rajkumar Manoharan <rmanohar@qti.qualcomm.com> Applied, thanks for fixing this. I also CCed stable. But I'm not actually sure if the "Fixes" lines implies "Cc stable"? I think I saw one patch going into stable like that so I have been wondering how this works. Does anyone know?
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index 78999c9..c42866d 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -4489,7 +4489,10 @@ static int ath10k_add_interface(struct ieee80211_hw *hw, goto err_vdev_delete; } - if (ar->cfg_tx_chainmask) { + /* Configuring number of spatial stream for monitor interface is causing + * target assert in qca9888 and qca6174. + */ + if (ar->cfg_tx_chainmask && (vif->type != NL80211_IFTYPE_MONITOR)) { u16 nss = get_nss_from_chainmask(ar->cfg_tx_chainmask); vdev_param = ar->wmi.vdev_param->nss;
commit 166de3f1895d ("ath10k: remove supported chain mask") had revealed an issue on monitor mode. Configuring NSS upon monitor interface creation is causing target assert in all qca9888x and qca6174 firmware. Firmware assert issue can be reproduced by below sequence even after reverting commit 166de3f1895d ("ath10k: remove supported chain mask"). ip link set wlan0 down iw wlan0 set type monitor iw phy0 set antenna 7 ip link set wlan0 up This issue is originally reported on qca9888 with 10.1 firmware. Fixes: 5572a95b4b ("ath10k: apply chainmask settings to vdev on creation") Reported-by: Janusz Dziedzic <janusz.dziedzic@tieto.com> Signed-off-by: Rajkumar Manoharan <rmanohar@qti.qualcomm.com> --- drivers/net/wireless/ath/ath10k/mac.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)