@@ -336,6 +336,7 @@ enum ieee80211_bss_change {
BSS_CHANGED_OCB = 1<<22,
BSS_CHANGED_MU_GROUPS = 1<<23,
BSS_CHANGED_KEEP_ALIVE = 1<<24,
+ BSS_CHANGED_MCAST_RATE = 1<<25,
/* when adding here, make sure to change ieee80211_reconfig */
};
@@ -2313,6 +2313,8 @@ static int ieee80211_set_mcast_rate(struct wiphy *wiphy, struct net_device *dev,
memcpy(sdata->vif.bss_conf.mcast_rate, rate,
sizeof(int) * NUM_NL80211_BANDS);
+ ieee80211_bss_info_change_notify(sdata, BSS_CHANGED_MCAST_RATE);
+
return 0;
}
@@ -1840,7 +1840,7 @@ int ieee80211_ibss_join(struct ieee80211_sub_if_data *sdata,
IEEE80211_HT_OP_MODE_PROTECTION_NONHT_MIXED
| IEEE80211_HT_PARAM_RIFS_MODE;
- changed |= BSS_CHANGED_HT;
+ changed |= BSS_CHANGED_HT | BSS_CHANGED_MCAST_RATE;
ieee80211_bss_info_change_notify(sdata, changed);
sdata->smps_mode = IEEE80211_SMPS_OFF;
@@ -884,7 +884,8 @@ int ieee80211_start_mesh(struct ieee80211_sub_if_data *sdata)
BSS_CHANGED_BEACON_ENABLED |
BSS_CHANGED_HT |
BSS_CHANGED_BASIC_RATES |
- BSS_CHANGED_BEACON_INT;
+ BSS_CHANGED_BEACON_INT |
+ BSS_CHANGED_MCAST_RATE;
local->fif_other_bss++;
/* mesh ifaces must set allmulti to forward mcast traffic */
@@ -1971,7 +1971,8 @@ int ieee80211_reconfig(struct ieee80211_local *local)
BSS_CHANGED_CQM |
BSS_CHANGED_QOS |
BSS_CHANGED_IDLE |
- BSS_CHANGED_TXPOWER;
+ BSS_CHANGED_TXPOWER |
+ BSS_CHANGED_MCAST_RATE;
if (sdata->vif.mu_mimo_owner)
changed |= BSS_CHANGED_MU_GROUPS;
It is required to pass the rate information to driver/firmware when rate control is offloaded to firmware. This helps in changing multicast traffic rates thereby improving the network performance. Signed-off-by: Pradeep Kumar Chitrapu <pradeepc@codeaurora.org> --- V2: - Set the flag in missing places include/net/mac80211.h | 1 + net/mac80211/cfg.c | 2 ++ net/mac80211/ibss.c | 2 +- net/mac80211/mesh.c | 3 ++- net/mac80211/util.c | 3 ++- 5 files changed, 8 insertions(+), 3 deletions(-)