===================================================================
@@ -817,6 +817,10 @@ struct b43_wldev {
/* Debugging stuff follows. */
#ifdef CONFIG_B43_DEBUG
struct b43_dfsentry *dfsentry;
+ unsigned int irq_count;
+ unsigned int irq_bit_count[32];
+ unsigned int tx_count;
+ unsigned int rx_count;
#endif
};
===================================================================
@@ -689,6 +689,7 @@ static void b43_add_dynamic_debug(struct
add_dyn_dbg("debug_lo", B43_DBG_LO, 0);
add_dyn_dbg("debug_firmware", B43_DBG_FIRMWARE, 0);
add_dyn_dbg("debug_keys", B43_DBG_KEYS, 0);
+ add_dyn_dbg("debug_verbose_stats", B43_DBG_VERBOSESTATS, 0);
#undef add_dyn_dbg
}
===================================================================
@@ -13,6 +13,7 @@ enum b43_dyndbg { /* Dynamic debugging
B43_DBG_LO,
B43_DBG_FIRMWARE,
B43_DBG_KEYS,
+ B43_DBG_VERBOSESTATS,
__B43_NR_DYNDBG,
};
===================================================================
@@ -1830,6 +1830,16 @@ static void b43_do_interrupt_thread(stru
/* Re-enable interrupts on the device by restoring the current interrupt mask. */
b43_write32(dev, B43_MMIO_GEN_IRQ_MASK, dev->irq_mask);
+
+#if B43_DEBUG
+ if (b43_debug(dev, B43_DBG_VERBOSESTATS)) {
+ dev->irq_count++;
+ for (i = 0; i < ARRAY_SIZE(dev->irq_bit_count); i++) {
+ if (reason & (1 << i))
+ dev->irq_bit_count[i]++;
+ }
+ }
+#endif
}
/* Interrupt thread handler. Handles device interrupts in thread context. */
@@ -2893,6 +2903,27 @@ static void b43_periodic_every15sec(stru
atomic_set(&phy->txerr_cnt, B43_PHY_TX_BADNESS_LIMIT);
wmb();
+
+#if B43_DEBUG
+ if (b43_debug(dev, B43_DBG_VERBOSESTATS)) {
+ unsigned int i;
+
+ b43dbg(dev->wl, "Stats: %7u IRQs/sec, %7u TX/sec, %7u RX/sec\n",
+ dev->irq_count / 15,
+ dev->tx_count / 15,
+ dev->rx_count / 15);
+ dev->irq_count = 0;
+ dev->tx_count = 0;
+ dev->rx_count = 0;
+ for (i = 0; i < ARRAY_SIZE(dev->irq_bit_count); i++) {
+ if (dev->irq_bit_count[i]) {
+ b43dbg(dev->wl, "Stats: %7u IRQ-%02u/sec (0x%08X)\n",
+ dev->irq_bit_count[i] / 15, i, (1 << i));
+ dev->irq_bit_count[i] = 0;
+ }
+ }
+ }
+#endif
}
static void do_periodic_work(struct b43_wldev *dev)
@@ -3092,6 +3123,9 @@ static void b43_tx_work(struct work_stru
dev_kfree_skb(skb); /* Drop it */
}
+#if B43_DEBUG
+ dev->tx_count++;
+#endif
mutex_unlock(&wl->mutex);
}
===================================================================
@@ -692,6 +692,9 @@ void b43_rx(struct b43_wldev *dev, struc
memcpy(IEEE80211_SKB_RXCB(skb), &status, sizeof(status));
ieee80211_rx(dev->wl->hw, skb);
+#if B43_DEBUG
+ dev->rx_count++;
+#endif
return;
drop:
b43dbg(dev->wl, "RX: Packet dropped\n");
This adds support for verbose runtime statistics. It defaults to off and must be enabled in debugfs, if desired. The first measurement may be incorrect, because statistics are not cleared after they got enabled through debugfs. Signed-off-by: Michael Buesch <mb@bu3sch.de> ---