@@ -785,6 +785,9 @@ mt76x2_init_txpower(struct mt76x2_dev *dev,
chan->max_power = mt76x2_get_max_rate_power(&t) +
target_power;
chan->max_power /= 2;
+
+ /* convert to combined output power on 2x2 devices */
+ chan->max_power += 3;
}
}
@@ -155,6 +155,9 @@ mt76x2_config(struct ieee80211_hw *hw, u32 changed)
if (changed & IEEE80211_CONF_CHANGE_POWER) {
dev->txpower_conf = hw->conf.power_level * 2;
+ /* convert to per-chain power for 2x2 devices */
+ dev->txpower_conf -= 6;
+
if (test_bit(MT76_STATE_RUNNING, &dev->mt76.state)) {
mt76x2_phy_set_txpower(dev);
mt76x2_tx_set_txpwr_auto(dev, dev->txpower_conf);
@@ -443,6 +446,10 @@ mt76x2_get_txpower(struct ieee80211_hw *hw, struct ieee80211_vif *vif, int *dbm)
struct mt76x2_dev *dev = hw->priv;
*dbm = dev->txpower_cur / 2;
+
+ /* convert from per-chain power to combined output on 2x2 devices */
+ *dbm += 3;
+
return 0;
}
Using both chains adds max. 3 dBm. A similar worst-case calculation is being used in ath9k as well to ensure that the hardware stays within regulatory limits Signed-off-by: Felix Fietkau <nbd@nbd.name> --- drivers/net/wireless/mediatek/mt76/mt76x2_init.c | 3 +++ drivers/net/wireless/mediatek/mt76/mt76x2_main.c | 7 +++++++ 2 files changed, 10 insertions(+)