@@ -425,7 +425,6 @@ static void rtl92c_dm_initial_gain_sta(struct ieee80211_hw *hw)
if (dm_digtable->presta_cstate == dm_digtable->cursta_cstate ||
dm_digtable->cursta_cstate == DIG_STA_BEFORE_CONNECT ||
dm_digtable->cursta_cstate == DIG_STA_CONNECT) {
-
if (dm_digtable->cursta_cstate != DIG_STA_DISCONNECT) {
dm_digtable->rssi_val_min =
rtl92c_dm_initial_gain_min_pwdb(hw);
@@ -504,7 +503,6 @@ static void rtl92c_dm_ctrl_initgain_by_twoport(struct ieee80211_hw *hw)
rtl92c_dm_cck_packet_detection_thresh(hw);
dm_digtable->presta_cstate = dm_digtable->cursta_cstate;
-
}
static void rtl92c_dm_dig(struct ieee80211_hw *hw)
@@ -607,6 +605,7 @@ static void rtl92c_dm_pwdb_monitor(struct ieee80211_hw *hw)
void rtl92c_dm_init_edca_turbo(struct ieee80211_hw *hw)
{
struct rtl_priv *rtlpriv = rtl_priv(hw);
+
rtlpriv->dm.current_turbo_edca = false;
rtlpriv->dm.is_any_nonbepkts = false;
rtlpriv->dm.is_cur_rdlstate = false;
@@ -660,7 +659,6 @@ static void rtl92c_dm_check_edca_turbo(struct ieee80211_hw *hw)
if ((bt_change_edca) || ((!rtlpriv->dm.is_any_nonbepkts) &&
(!rtlpriv->dm.disable_framebursting))) {
-
cur_txok_cnt = rtlpriv->stats.txbytesunicast - last_txok_cnt;
cur_rxok_cnt = rtlpriv->stats.rxbytesunicast - last_rxok_cnt;
@@ -685,6 +683,7 @@ static void rtl92c_dm_check_edca_turbo(struct ieee80211_hw *hw)
} else {
if (rtlpriv->dm.current_turbo_edca) {
u8 tmp = AC0_BE;
+
rtlpriv->cfg->ops->set_hw_reg(hw, HW_VAR_AC_PARAM,
&tmp);
rtlpriv->dm.current_turbo_edca = false;
@@ -1634,7 +1633,6 @@ static void rtl92c_bt_ant_isolation(struct ieee80211_hw *hw, u8 tmp1byte)
{
struct rtl_priv *rtlpriv = rtl_priv(hw);
-
/* Only enable HW BT coexist when BT in "Busy" state. */
if (rtlpriv->mac80211.vendor == PEER_CISCO &&
rtlpriv->btcoexist.bt_service == BT_OTHER_ACTION) {
@@ -18,6 +18,7 @@ static void _rtl92c_enable_fw_download(struct ieee80211_hw *hw, bool enable)
if (rtlhal->hw_type == HARDWARE_TYPE_RTL8192CU) {
u32 value32 = rtl_read_dword(rtlpriv, REG_MCUFWDL);
+
if (enable)
value32 |= MCUFWDL_EN;
else
@@ -25,8 +26,8 @@ static void _rtl92c_enable_fw_download(struct ieee80211_hw *hw, bool enable)
rtl_write_dword(rtlpriv, REG_MCUFWDL, value32);
} else if (rtlhal->hw_type == HARDWARE_TYPE_RTL8192CE) {
u8 tmp;
- if (enable) {
+ if (enable) {
tmp = rtl_read_byte(rtlpriv, REG_SYS_FUNC_EN + 1);
rtl_write_byte(rtlpriv, REG_SYS_FUNC_EN + 1,
tmp | 0x04);
@@ -37,7 +38,6 @@ static void _rtl92c_enable_fw_download(struct ieee80211_hw *hw, bool enable)
tmp = rtl_read_byte(rtlpriv, REG_MCUFWDL + 2);
rtl_write_byte(rtlpriv, REG_MCUFWDL + 2, tmp & 0xf7);
} else {
-
tmp = rtl_read_byte(rtlpriv, REG_MCUFWDL);
rtl_write_byte(rtlpriv, REG_MCUFWDL, tmp & 0xfe);
@@ -622,7 +622,6 @@ void rtl92c_set_fw_rsvdpagepkt(struct ieee80211_hw *hw,
"rtl92c_set_fw_rsvdpagepkt(): HW_VAR_SET_TX_CMD: ALL\n",
u1rsvdpageloc, 3);
-
skb = dev_alloc_skb(totalpacketlen);
skb_put_data(skb, &reserved_page_packet, totalpacketlen);
@@ -4,7 +4,6 @@
#include "../wifi.h"
#include <linux/module.h>
-
MODULE_AUTHOR("lizhaoming <chaoming_li@realsil.com.cn>");
MODULE_AUTHOR("Realtek WlanFAE <wlanfae@realtek.com>");
MODULE_AUTHOR("Georgia <georgia@realtek.com>");
@@ -747,6 +747,7 @@ static void _rtl92c_phy_sw_rf_seting(struct ieee80211_hw *hw, u8 channel)
struct rtl_priv *rtlpriv = rtl_priv(hw);
struct rtl_phy *rtlphy = &(rtlpriv->phy);
struct rtl_hal *rtlhal = rtl_hal(rtl_priv(hw));
+
if (IS_81XXC_VENDOR_UMC_B_CUT(rtlhal->version)) {
if (channel == 6 &&
rtlphy->current_chan_bw == HT_CHANNEL_WIDTH_20) {
The following types of blank line problems are reported: WARNING: Missing a blank line after declarations CHECK: Please don't use multiple blank lines There are no code changes. Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net> --- drivers/net/wireless/realtek/rtlwifi/rtl8192c/dm_common.c | 6 ++---- drivers/net/wireless/realtek/rtlwifi/rtl8192c/fw_common.c | 5 ++--- drivers/net/wireless/realtek/rtlwifi/rtl8192c/main.c | 1 - drivers/net/wireless/realtek/rtlwifi/rtl8192c/phy_common.c | 1 + 4 files changed, 5 insertions(+), 8 deletions(-)