@@ -757,7 +757,7 @@ void ath11k_hal_reo_qdesc_setup(void *vaddr, int tid, u32 ba_window_size,
/* TODO: HW queue descriptors are currently allocated for max BA
* window size for all QOS TIDs so that same descriptor can be used
- * later when ADDBA request is recevied. This should be changed to
+ * later when ADDBA request is received. This should be changed to
* allocate HW queue descriptors based on BA window size being
* negotiated (0 for non BA cases), and reallocate when BA window
* size changes and also send WMI message to FW to change the REO
@@ -7833,7 +7833,7 @@ ath11k_mac_op_set_bitrate_mask(struct ieee80211_hw *hw,
he_ltf = mask->control[band].he_ltf;
/* mac80211 doesn't support sending a fixed HT/VHT MCS alone, rather it
- * requires passing atleast one of used basic rates along with them.
+ * requires passing at least one of used basic rates along with them.
* Fixed rate setting across different preambles(legacy, HT, VHT) is
* not supported by the FW. Hence use of FIXED_RATE vdev param is not
* suitable for setting single HT/VHT rates.
@@ -2229,13 +2229,13 @@ static int ath11k_qmi_request_target_cap(struct ath11k_base *ab)
if (resp.fw_version_info_valid) {
ab->qmi.target.fw_version = resp.fw_version_info.fw_version;
- strlcpy(ab->qmi.target.fw_build_timestamp,
+ strscpy(ab->qmi.target.fw_build_timestamp,
resp.fw_version_info.fw_build_timestamp,
sizeof(ab->qmi.target.fw_build_timestamp));
}
if (resp.fw_build_id_valid)
- strlcpy(ab->qmi.target.fw_build_id, resp.fw_build_id,
+ strscpy(ab->qmi.target.fw_build_id, resp.fw_build_id,
sizeof(ab->qmi.target.fw_build_id));
if (resp.eeprom_read_timeout_valid) {
@@ -2659,7 +2659,7 @@ static int ath11k_qmi_wlanfw_wlan_cfg_send(struct ath11k_base *ab)
memset(&resp, 0, sizeof(resp));
req->host_version_valid = 1;
- strlcpy(req->host_version, ATH11K_HOST_VERSION_STRING,
+ strscpy(req->host_version, ATH11K_HOST_VERSION_STRING,
sizeof(req->host_version));
req->tgt_cfg_valid = 1;
@@ -6563,7 +6563,7 @@ static int ath11k_reg_chan_list_event(struct ath11k_base *ab, struct sk_buff *sk
fallback:
/* Fallback to older reg (by sending previous country setting
- * again if fw has succeded and we failed to process here.
+ * again if fw has succeeded and we failed to process here.
* The Regdomain should be uniform across driver and fw. Since the
* FW has processed the command and sent a success status, we expect
* this function to succeed as well. If it doesn't, CTRY needs to be
Fix warnings reported by checkpatch tool. Below are the errors fixed, drivers/net/wireless/ath/ath11k/hal_rx.c:760: 'recevied' may be misspelled - perhaps 'received? drivers/net/wireless/ath/ath11k/qmi.c:2232: Prefer strscpy over strlcpy drivers/net/wireless/ath/ath11k/qmi.c:2238: Prefer strscpy over strlcpy drivers/net/wireless/ath/ath11k/qmi.c:2662: Prefer strscpy over strlcpy drivers/net/wireless/ath/ath11k/mac.c:7836: 'atleast' may be misspelled - perhaps 'at least'? drivers/net/wireless/ath/ath11k/wmi.c:6566: 'succeded' may be misspelled - perhaps 'succeeded'? Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1 Signed-off-by: Manikanta Pubbisetty <quic_mpubbise@quicinc.com> --- drivers/net/wireless/ath/ath11k/hal_rx.c | 2 +- drivers/net/wireless/ath/ath11k/mac.c | 2 +- drivers/net/wireless/ath/ath11k/qmi.c | 6 +++--- drivers/net/wireless/ath/ath11k/wmi.c | 2 +- 4 files changed, 6 insertions(+), 6 deletions(-)