diff mbox series

[7/7] rtlwifi: rtl8821ae: Access full PMCS reg and use pci_regs.h

Message ID 20231117094425.80477-8-ilpo.jarvinen@linux.intel.com (mailing list archive)
State Changes Requested
Delegated to: Kalle Valo
Headers show
Series rtlwifi: PCIe capability access fix + improvements | expand

Commit Message

Ilpo Järvinen Nov. 17, 2023, 9:44 a.m. UTC
_rtl8821ae_clear_pci_pme_status() accesses the upper byte of the Power
Management Control/Status register (PMCS) with literal 5 offset.

Access the entire PMCS register using defines from pci_regs.h to
improve code readability.

While at it, remove the obvious comment and tweak debug prints
slightly to not sound misleading.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
---
 .../wireless/realtek/rtlwifi/rtl8821ae/hw.c   | 21 +++++++------------
 1 file changed, 7 insertions(+), 14 deletions(-)

Comments

Bjorn Helgaas Nov. 17, 2023, 10:48 p.m. UTC | #1
On Fri, Nov 17, 2023 at 11:44:25AM +0200, Ilpo Järvinen wrote:
> _rtl8821ae_clear_pci_pme_status() accesses the upper byte of the Power
> Management Control/Status register (PMCS) with literal 5 offset.
> 
> Access the entire PMCS register using defines from pci_regs.h to
> improve code readability.
> 
> While at it, remove the obvious comment and tweak debug prints
> slightly to not sound misleading.

OK, ignore my previous comments ;)  I should read all the way through
before responding.
Ilpo Järvinen Nov. 20, 2023, 10:06 a.m. UTC | #2
On Fri, 17 Nov 2023, Bjorn Helgaas wrote:

> On Fri, Nov 17, 2023 at 11:44:25AM +0200, Ilpo Järvinen wrote:
> > _rtl8821ae_clear_pci_pme_status() accesses the upper byte of the Power
> > Management Control/Status register (PMCS) with literal 5 offset.
> > 
> > Access the entire PMCS register using defines from pci_regs.h to
> > improve code readability.
> > 
> > While at it, remove the obvious comment and tweak debug prints
> > slightly to not sound misleading.
> 
> OK, ignore my previous comments ;)  I should read all the way through
> before responding.

Please don't do that because then you'll just end up forgetting useful 
comments. :-)

I had this all in one patch initially but thought it's better to split it 
a bit.

Thanks a lot for reviewing.
diff mbox series

Patch

diff --git a/drivers/net/wireless/realtek/rtlwifi/rtl8821ae/hw.c b/drivers/net/wireless/realtek/rtlwifi/rtl8821ae/hw.c
index 7cc648d49f2d..f4b232f038a9 100644
--- a/drivers/net/wireless/realtek/rtlwifi/rtl8821ae/hw.c
+++ b/drivers/net/wireless/realtek/rtlwifi/rtl8821ae/hw.c
@@ -2271,7 +2271,7 @@  static void _rtl8821ae_clear_pci_pme_status(struct ieee80211_hw *hw)
 	struct rtl_priv *rtlpriv = rtl_priv(hw);
 	struct rtl_pci *rtlpci = rtl_pcidev(rtl_pcipriv(hw));
 	struct pci_dev *pdev = rtlpci->pdev;
-	u8 pmcs_reg;
+	u16 pmcs_reg;
 	u8 pm_cap;
 
 	pm_cap = pci_find_capability(pdev, PCI_CAP_ID_PM);
@@ -2281,23 +2281,16 @@  static void _rtl8821ae_clear_pci_pme_status(struct ieee80211_hw *hw)
 		return;
 	}
 
-	/* Get the PM CSR (Control/Status Register),
-	 * The PME_Status is located at PM Capatibility offset 5, bit 7
-	 */
-	pci_read_config_byte(pdev, pm_cap + 5, &pmcs_reg);
-
-	if (pmcs_reg & BIT(7)) {
+	pci_read_config_word(pdev, pm_cap + PCI_PM_CTRL, &pmcs_reg);
+	if (pmcs_reg & PCI_PM_CTRL_PME_STATUS) {
 		/* Clear PME_Status with write */
-		pci_write_config_byte(pdev, pm_cap + 5, pmcs_reg);
-		/* Read it back to check */
-		pci_read_config_byte(pdev, pm_cap + 5, &pmcs_reg);
+		pci_write_config_word(pdev, pm_cap + PCI_PM_CTRL, pmcs_reg);
+		pci_read_config_word(pdev, pm_cap + PCI_PM_CTRL, &pmcs_reg);
 		rtl_dbg(rtlpriv, COMP_INIT, DBG_DMESG,
-			"Clear PME status 0x%2x to 0x%2x\n",
-			pm_cap + 5, pmcs_reg);
+			"Cleared PME status, PMCS reg = 0x%4x\n", pmcs_reg);
 	} else {
 		rtl_dbg(rtlpriv, COMP_INIT, DBG_DMESG,
-			"PME status(0x%2x) = 0x%2x\n",
-			pm_cap + 5, pmcs_reg);
+			"PMCS reg = 0x%4x\n", pmcs_reg);
 	}
 }