@@ -452,8 +452,6 @@ static void ath12k_dp_srng_common_cleanup(struct ath12k_base *ab)
ath12k_dp_srng_cleanup(ab, &dp->tx_ring[i].tcl_comp_ring);
ath12k_dp_srng_cleanup(ab, &dp->tx_ring[i].tcl_data_ring);
}
- ath12k_dp_srng_cleanup(ab, &dp->tcl_status_ring);
- ath12k_dp_srng_cleanup(ab, &dp->tcl_cmd_ring);
ath12k_dp_srng_cleanup(ab, &dp->wbm_desc_rel_ring);
}
@@ -474,20 +472,6 @@ static int ath12k_dp_srng_common_setup(struct ath12k_base *ab)
goto err;
}
- ret = ath12k_dp_srng_setup(ab, &dp->tcl_cmd_ring, HAL_TCL_CMD, 0, 0,
- DP_TCL_CMD_RING_SIZE);
- if (ret) {
- ath12k_warn(ab, "failed to set up tcl_cmd ring :%d\n", ret);
- goto err;
- }
-
- ret = ath12k_dp_srng_setup(ab, &dp->tcl_status_ring, HAL_TCL_STATUS,
- 0, 0, DP_TCL_STATUS_RING_SIZE);
- if (ret) {
- ath12k_warn(ab, "failed to set up tcl_status ring :%d\n", ret);
- goto err;
- }
-
for (i = 0; i < ab->hw_params->max_tx_ring; i++) {
map = ab->hw_params->hal_ops->tcl_to_wbm_rbm_map;
tx_comp_ring_num = map[i].wbm_ring_num;
@@ -316,8 +316,6 @@ struct ath12k_dp {
struct dp_link_desc_bank link_desc_banks[DP_LINK_DESC_BANKS_MAX];
struct dp_srng wbm_idle_ring;
struct dp_srng wbm_desc_rel_ring;
- struct dp_srng tcl_cmd_ring;
- struct dp_srng tcl_status_ring;
struct dp_srng reo_reinject_ring;
struct dp_srng rx_rel_ring;
struct dp_srng reo_except_ring;
Currently memory allocation for multiple hardware rings done in host as these memory will be used by firmware/hardware. But in case of tcl_cmd_ring and tcl_status_ring neither firmware nor hardware uses host allocated memory and it uses memory allocated by firmware itself. So avoid tcl_cmd_ring and tcl_status_ring setup in host. Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1 Signed-off-by: Tamizh Chelvam Raja <quic_tamizhr@quicinc.com> --- drivers/net/wireless/ath/ath12k/dp.c | 16 ---------------- drivers/net/wireless/ath/ath12k/dp.h | 2 -- 2 files changed, 18 deletions(-)