[net-next,v2,0/6] TXGBE PHYLINK support

Message

Jiawen Wu April 11, 2023, 9:27 a.m. UTC

Implement I2C, SFP, GPIO and PHYLINK to setup TXGBE link and switch link
rate based on optical module information.

v1 -> v2:
- add comments to indicate GPIO lines
- add I2C write operation support
- modify GPIO direction functions
- rename functions related to PHY interface
- add condition on interface changing to re-config PCS
- add to set advertise and fix to get status for 1000BASE-X mode
- other redundant codes remove

Jiawen Wu (6):
  net: txgbe: Add software nodes to support phylink
  net: txgbe: Implement I2C bus master driver
  net: txgbe: Add SFP module identify
  net: txgbe: Support GPIO to SFP socket
  net: txgbe: Implement phylink pcs
  net: txgbe: Support phylink MAC layer

 drivers/net/ethernet/wangxun/Kconfig          |   5 +
 drivers/net/ethernet/wangxun/libwx/wx_lib.c   |   3 +-
 drivers/net/ethernet/wangxun/libwx/wx_type.h  |   3 +
 drivers/net/ethernet/wangxun/txgbe/Makefile   |   1 +
 .../ethernet/wangxun/txgbe/txgbe_ethtool.c    |  34 +
 .../net/ethernet/wangxun/txgbe/txgbe_main.c   |  58 +-
 .../net/ethernet/wangxun/txgbe/txgbe_phy.c    | 980 ++++++++++++++++++
 .../net/ethernet/wangxun/txgbe/txgbe_phy.h    |  10 +
 .../net/ethernet/wangxun/txgbe/txgbe_type.h   | 157 +++
 9 files changed, 1219 insertions(+), 32 deletions(-)
 create mode 100644 drivers/net/ethernet/wangxun/txgbe/txgbe_phy.c
 create mode 100644 drivers/net/ethernet/wangxun/txgbe/txgbe_phy.h