@@ -754,36 +754,6 @@ static void at803x_link_change_notify(struct phy_device *phydev)
}
}
-static int at803x_aneg_done(struct phy_device *phydev)
-{
- int ccr;
-
- int aneg_done = genphy_aneg_done(phydev);
- if (aneg_done != BMSR_ANEGCOMPLETE)
- return aneg_done;
-
- /*
- * in SGMII mode, if copper side autoneg is successful,
- * also check SGMII side autoneg result
- */
- ccr = phy_read(phydev, AT803X_REG_CHIP_CONFIG);
- if ((ccr & AT803X_MODE_CFG_MASK) != AT803X_MODE_CFG_SGMII)
- return aneg_done;
-
- /* switch to SGMII/fiber page */
- phy_write(phydev, AT803X_REG_CHIP_CONFIG, ccr & ~AT803X_BT_BX_REG_SEL);
-
- /* check if the SGMII link is OK. */
- if (!(phy_read(phydev, AT803X_PSSR) & AT803X_PSSR_MR_AN_COMPLETE)) {
- phydev_warn(phydev, "803x_aneg_done: SGMII link is not ok\n");
- aneg_done = 0;
- }
- /* switch back to copper page */
- phy_write(phydev, AT803X_REG_CHIP_CONFIG, ccr | AT803X_BT_BX_REG_SEL);
-
- return aneg_done;
-}
-
static int at803x_read_status(struct phy_device *phydev)
{
int ss, err, old_link = phydev->link;
@@ -1233,7 +1203,6 @@ static struct phy_driver at803x_driver[] = {
.resume = at803x_resume,
/* PHY_GBIT_FEATURES */
.read_status = at803x_read_status,
- .aneg_done = at803x_aneg_done,
.config_intr = &at803x_config_intr,
.handle_interrupt = at803x_handle_interrupt,
.get_tunable = at803x_get_tunable,
at803x_aneg_done() is pretty much dead code since the patch series "net: phy: improve and simplify phylib state machine" [1]. Just remove it. [1] https://lore.kernel.org/netdev/922c223b-7bc0-e0ec-345d-2034b796af91@gmail.com/ Suggested-by: Vladimir Oltean <olteanv@gmail.com> Signed-off-by: Michael Walle <michael@walle.cc> --- drivers/net/phy/at803x.c | 31 ------------------------------- 1 file changed, 31 deletions(-)