@@ -1977,11 +1977,12 @@ static int netsec_register_mdio(struct netsec_priv *priv, u32 phy_addr)
static int netsec_probe(struct platform_device *pdev)
{
- struct resource *mmio_res, *eeprom_res, *irq_res;
+ struct resource *mmio_res, *eeprom_res;
struct netsec_priv *priv;
u32 hw_ver, phy_addr = 0;
struct net_device *ndev;
int ret;
+ int irq;
mmio_res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (!mmio_res) {
@@ -1995,11 +1996,9 @@ static int netsec_probe(struct platform_device *pdev)
return -ENODEV;
}
- irq_res = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
- if (!irq_res) {
- dev_err(&pdev->dev, "No IRQ resource found.\n");
- return -ENODEV;
- }
+ irq = platform_get_irq(pdev, 0);
+ if (irq < 0)
+ return irq;
ndev = alloc_etherdev(sizeof(*priv));
if (!ndev)
@@ -2010,7 +2009,7 @@ static int netsec_probe(struct platform_device *pdev)
spin_lock_init(&priv->reglock);
SET_NETDEV_DEV(ndev, &pdev->dev);
platform_set_drvdata(pdev, priv);
- ndev->irq = irq_res->start;
+ ndev->irq = irq;
priv->dev = &pdev->dev;
priv->ndev = ndev;
platform_get_resource(pdev, IORESOURCE_IRQ, ..) relies on static allocation of IRQ resources in DT core code, this causes an issue when using hierarchical interrupt domains using "interrupts" property in the node as this bypasses the hierarchical setup and messes up the irq chaining. In preparation for removal of static setup of IRQ resource from DT core code use platform_get_irq(). Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com> --- drivers/net/ethernet/socionext/netsec.c | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-)