@@ -63,6 +63,18 @@ Description: (RW) Contains the current synchronization source used by
the PHC. May be changed by writing one of the listed
values from the available_clock_sources attribute set.
+What: /sys/class/timecard/ocpN/clock_status_drift
+Date: March 2022
+Contact: Jonathan Lemon <jonathan.lemon@gmail.com>
+Description: (RO) Contains the current drift value used by the firmware
+ for internal disciplining of the atomic clock.
+
+What: /sys/class/timecard/ocpN/clock_status_offset
+Date: March 2022
+Contact: Jonathan Lemon <jonathan.lemon@gmail.com>
+Description: (RO) Contains the current offset value used by the firmware
+ for internal disciplining of the atomic clock.
+
What: /sys/class/timecard/ocpN/gnss_sync
Date: September 2021
Contact: Jonathan Lemon <jonathan.lemon@gmail.com>
@@ -126,6 +138,16 @@ Description: (RW) These attributes specify the direction of the signal
The 10Mhz reference clock input is currently only valid
on SMA1 and may not be combined with other destination sinks.
+What: /sys/class/timecard/ocpN/tod_correction
+Date: March 2022
+Contact: Jonathan Lemon <jonathan.lemon@gmail.com>
+Description: (RW) The incoming GNSS signal is in UTC time, and the NMEA
+ format messages do not provide a TAI offset. This sets the
+ correction value for the incoming time.
+
+ If UBX_LS is enabled, this should be 0, and the offset is
+ taken from the UBX-NAV-TIMELS message.
+
What: /sys/class/timecard/ocpN/ts_window_adjust
Date: September 2021
Contact: Jonathan Lemon <jonathan.lemon@gmail.com>
Add documentation for the tod_correction, clock_status_drift, and clock_status_offset nodes. Signed-off-by: Jonathan Lemon <jonathan.lemon@gmail.com> --- Documentation/ABI/testing/sysfs-timecard | 22 ++++++++++++++++++++++ 1 file changed, 22 insertions(+)