@@ -45,20 +45,3 @@ Optional properties:
In fiber mode, auto-negotiation is disabled and the PHY can only work in
100base-fx (full and half duplex) modes.
-
- - lan8814,ignore-ts: If present the PHY will not support timestamping.
-
- This option acts as check whether Timestamping is supported by
- hardware or not. LAN8814 phy support hardware tmestamping.
-
- - lan8814,latency_rx_10: Configures Latency value of phy in ingress at 10 Mbps.
-
- - lan8814,latency_tx_10: Configures Latency value of phy in egress at 10 Mbps.
-
- - lan8814,latency_rx_100: Configures Latency value of phy in ingress at 100 Mbps.
-
- - lan8814,latency_tx_100: Configures Latency value of phy in egress at 100 Mbps.
-
- - lan8814,latency_rx_1000: Configures Latency value of phy in ingress at 1000 Mbps.
-
- - lan8814,latency_tx_1000: Configures Latency value of phy in egress at 1000 Mbps.
Revert latency support from binding. Based on the discussion[1], the DT is the wrong place to have the lantecies for the PHY. [1] https://lkml.org/lkml/2022/3/4/325 Fixes: 2358dd3fd325fc ("dt-bindings: net: micrel: Configure latency values and timestamping check for LAN8814 phy") Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com> --- .../devicetree/bindings/net/micrel.txt | 17 ----------------- 1 file changed, 17 deletions(-)