@@ -130,9 +130,15 @@ static int mlxbf_gige_open(struct net_device *netdev)
{
struct mlxbf_gige *priv = netdev_priv(netdev);
struct phy_device *phydev = netdev->phydev;
+ u64 control;
u64 int_en;
int err;
+ /* Perform general init of GigE block */
+ control = readq(base + MLXBF_GIGE_CONTROL);
+ control |= MLXBF_GIGE_CONTROL_PORT_EN;
+ writeq(control, base + MLXBF_GIGE_CONTROL);
+
err = mlxbf_gige_request_irqs(priv);
if (err)
return err;
@@ -365,7 +371,6 @@ static int mlxbf_gige_probe(struct platform_device *pdev)
void __iomem *plu_base;
void __iomem *base;
int addr, phy_irq;
- u64 control;
int err;
base = devm_platform_ioremap_resource(pdev, MLXBF_GIGE_RES_MAC);
@@ -380,11 +385,6 @@ static int mlxbf_gige_probe(struct platform_device *pdev)
if (IS_ERR(plu_base))
return PTR_ERR(plu_base);
- /* Perform general init of GigE block */
- control = readq(base + MLXBF_GIGE_CONTROL);
- control |= MLXBF_GIGE_CONTROL_PORT_EN;
- writeq(control, base + MLXBF_GIGE_CONTROL);
-
netdev = devm_alloc_etherdev(&pdev->dev, sizeof(*priv));
if (!netdev)
return -ENOMEM;
At the moment, the GigE port is enabled in the mlxbf_gige_probe function. If the mlxbf_gige_open is not executed, this could cause pause frames to increase in the case where there is high backgroud traffic. This results in clogging the port. So move enabling the OOB port to mlxbf_gige_open. Fixes: f92e1869d74e ("Add Mellanox BlueField Gigabit Ethernet driver") Signed-off-by: Asmaa Mnebhi <asmaa@nvidia.com> Reviewed-by: David Thompson <davthompson@nvidia.com> --- .../ethernet/mellanox/mlxbf_gige/mlxbf_gige_main.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)