@@ -224,10 +224,13 @@ static void veth_get_channels(struct net_device *dev,
{
channels->tx_count = dev->real_num_tx_queues;
channels->rx_count = dev->real_num_rx_queues;
- channels->max_tx = dev->real_num_tx_queues;
- channels->max_rx = dev->real_num_rx_queues;
+ channels->max_tx = dev->num_tx_queues;
+ channels->max_rx = dev->num_rx_queues;
}
+static int veth_set_channels(struct net_device *dev,
+ struct ethtool_channels *ch);
+
static const struct ethtool_ops veth_ethtool_ops = {
.get_drvinfo = veth_get_drvinfo,
.get_link = ethtool_op_get_link,
@@ -237,6 +240,7 @@ static const struct ethtool_ops veth_ethtool_ops = {
.get_link_ksettings = veth_get_link_ksettings,
.get_ts_info = ethtool_op_get_ts_info,
.get_channels = veth_get_channels,
+ .set_channels = veth_set_channels,
};
/* general routines */
@@ -1136,6 +1140,123 @@ static int veth_napi_enable(struct net_device *dev)
return veth_napi_enable_range(dev, 0, dev->real_num_rx_queues);
}
+static void veth_disable_range_safe(struct net_device *dev, int start, int end)
+{
+ struct veth_priv *priv = netdev_priv(dev);
+
+ if (start >= end)
+ return;
+
+ if (priv->_xdp_prog) {
+ veth_napi_del_range(dev, start, end);
+ veth_disable_xdp_range(dev, start, end, false);
+ } else if (veth_gro_requested(dev)) {
+ veth_napi_del_range(dev, start, end);
+ }
+}
+
+static int veth_enable_range_safe(struct net_device *dev, int start, int end)
+{
+ struct veth_priv *priv = netdev_priv(dev);
+ int err;
+
+ if (start >= end)
+ return 0;
+
+ if (priv->_xdp_prog) {
+ /* these channels are freshly initialized, napi is not on there even
+ * when GRO is requeste
+ */
+ err = veth_enable_xdp_range(dev, start, end, false);
+ if (err)
+ return err;
+
+ err = __veth_napi_enable_range(dev, start, end);
+ if (err) {
+ /* on error always delete the newly added napis */
+ veth_disable_xdp_range(dev, start, end, true);
+ return err;
+ }
+ } else if (veth_gro_requested(dev)) {
+ return veth_napi_enable_range(dev, start, end);
+ }
+ return 0;
+}
+
+static int veth_set_channels(struct net_device *dev,
+ struct ethtool_channels *ch)
+{
+ struct veth_priv *priv = netdev_priv(dev);
+ unsigned int old_rx_count, new_rx_count;
+ struct veth_priv *peer_priv;
+ struct net_device *peer;
+ int err;
+
+ /* sanity check. Upper bounds are already enforced by the caller */
+ if (!ch->rx_count || !ch->tx_count)
+ return -EINVAL;
+
+ /* avoid braking XDP, if that is enabled */
+ peer = rtnl_dereference(priv->peer);
+ peer_priv = peer ? netdev_priv(peer) : NULL;
+ if (priv->_xdp_prog && peer && ch->rx_count < peer->real_num_tx_queues)
+ return -EINVAL;
+
+ if (peer && peer_priv && peer_priv->_xdp_prog && ch->tx_count > peer->real_num_rx_queues)
+ return -EINVAL;
+
+ old_rx_count = dev->real_num_rx_queues;
+ new_rx_count = ch->rx_count;
+ if (netif_running(dev)) {
+ /* turn device off */
+ netif_carrier_off(dev);
+ if (peer)
+ netif_carrier_off(peer);
+
+ /* try to allocate new resurces, as needed*/
+ err = veth_enable_range_safe(dev, old_rx_count, new_rx_count);
+ if (err)
+ goto out;
+ }
+
+ err = netif_set_real_num_rx_queues(dev, ch->rx_count);
+ if (err)
+ goto revert;
+
+ err = netif_set_real_num_tx_queues(dev, ch->tx_count);
+ if (err) {
+ int err2 = netif_set_real_num_rx_queues(dev, old_rx_count);
+
+ /* this error condition could happen only if rx and tx change
+ * in opposite directions (e.g. tx nr raises, rx nr decreases)
+ * and we can't do anything to fully restore the original
+ * status
+ */
+ if (err2)
+ pr_warn("Can't restore rx queues config %d -> %d %d",
+ new_rx_count, old_rx_count, err2);
+ else
+ goto revert;
+ }
+
+out:
+ if (netif_running(dev)) {
+ /* note that we need to swap the arguments WRT the enable part
+ * to identify the range we have to disable
+ */
+ veth_disable_range_safe(dev, new_rx_count, old_rx_count);
+ netif_carrier_on(dev);
+ if (peer)
+ netif_carrier_on(peer);
+ }
+ return err;
+
+revert:
+ new_rx_count = old_rx_count;
+ old_rx_count = ch->rx_count;
+ goto out;
+}
+
static int veth_open(struct net_device *dev)
{
struct veth_priv *priv = netdev_priv(dev);
This change implements the set_channel() ethtool operation, preserving the current defaults values and allowing up set the number of queues in the range set ad device creation time. The update operation tries hard to leave the device in a consistent status in case of errors. RFC v1 -> RFC v2: - don't flip device status on set_channel() - roll-back the changes if possible on error - Jackub Signed-off-by: Paolo Abeni <pabeni@redhat.com> --- drivers/net/veth.c | 125 ++++++++++++++++++++++++++++++++++++++++++++- 1 file changed, 123 insertions(+), 2 deletions(-)