@@ -3742,7 +3742,6 @@ static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
struct myri10ge_priv *mgp;
struct device *dev = &pdev->dev;
int status = -ENXIO;
- int dac_enabled;
unsigned hdr_offset, ss_offset;
static int board_number;
@@ -3782,14 +3781,7 @@ static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
myri10ge_mask_surprise_down(pdev);
pci_set_master(pdev);
- dac_enabled = 1;
status = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));
- if (status != 0) {
- dac_enabled = 0;
- dev_err(&pdev->dev,
- "64-bit pci address mask was refused, trying 32-bit\n");
- status = dma_set_mask(&pdev->dev, DMA_BIT_MASK(32));
- }
if (status != 0) {
dev_err(&pdev->dev, "Error %d setting DMA mask\n", status);
goto abort_with_enabled;
@@ -3874,10 +3866,7 @@ static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
/* fake NETIF_F_HW_VLAN_CTAG_RX for good GRO performance */
netdev->hw_features |= NETIF_F_HW_VLAN_CTAG_RX;
- netdev->features = netdev->hw_features;
-
- if (dac_enabled)
- netdev->features |= NETIF_F_HIGHDMA;
+ netdev->features = netdev->hw_features | NETIF_F_HIGHDMA;
netdev->vlan_features |= mgp->features;
if (mgp->fw_ver_tiny < 37)
As stated in [1], dma_set_mask() with a 64-bit mask will never fail if dev->dma_mask is non-NULL. So, if it fails, the 32 bits case will also fail for the same reason. If dma_set_mask_and_coherent() succeeds, 'dac_enabled' is known to be 1. Simplify code and remove some dead code accordingly. [1]: https://lkml.org/lkml/2021/6/7/398 Signed-off-by: Christophe JAILLET <christophe.jaillet@wanadoo.fr> --- drivers/net/ethernet/myricom/myri10ge/myri10ge.c | 13 +------------ 1 file changed, 1 insertion(+), 12 deletions(-)