@@ -3453,7 +3453,7 @@ static int phy_probe(struct device *dev)
struct phy_device *phydev = to_phy_device(dev);
struct device_driver *drv = phydev->mdio.dev.driver;
struct phy_driver *phydrv = to_phy_driver(drv);
- int err = 0;
+ int err = 0, bmcr;
phydev->drv = phydrv;
@@ -3495,8 +3495,12 @@ static int phy_probe(struct device *dev)
if (err)
goto out;
+ err = bmcr = phy_read(phydev, MII_BMCR);
+ if (err < 0)
+ goto out;
+
if (!linkmode_test_bit(ETHTOOL_LINK_MODE_Autoneg_BIT,
- phydev->supported))
+ phydev->supported) || !(bmcr & BMCR_ANENABLE))
phydev->autoneg = 0;
if (linkmode_test_bit(ETHTOOL_LINK_MODE_1000baseT_Half_BIT,
phydev->autoneg appears to indicate if autonegotiation is enabled or not. Unfortunately it's initially set based on the supported capability rather than the actual hw setting. While in most cases there is no difference (i.e., autoneg is supported and on by default), certain adapters (e.g. fiber optics) use fixed settings, configured in hardware. Now autoneg flag is set only when it's supported and actually used. Signed-off-by: Krzysztof Hałasa <khalasa@piap.pl>