@@ -2215,7 +2215,6 @@ static bool vfio_add_std_cap(VFIOPCIDevice *vdev, uint8_t pos, Error **errp)
break;
case PCI_CAP_ID_PM:
vfio_check_pm_reset(vdev, pos);
- vdev->pm_cap = pos;
ret = pci_pm_init(pdev, pos, errp) >= 0;
break;
case PCI_CAP_ID_AF:
@@ -2407,17 +2406,17 @@ void vfio_pci_pre_reset(VFIOPCIDevice *vdev)
vfio_disable_interrupts(vdev);
/* Make sure the device is in D0 */
- if (vdev->pm_cap) {
+ if (pdev->pm_cap) {
uint16_t pmcsr;
uint8_t state;
- pmcsr = vfio_pci_read_config(pdev, vdev->pm_cap + PCI_PM_CTRL, 2);
+ pmcsr = vfio_pci_read_config(pdev, pdev->pm_cap + PCI_PM_CTRL, 2);
state = pmcsr & PCI_PM_CTRL_STATE_MASK;
if (state) {
pmcsr &= ~PCI_PM_CTRL_STATE_MASK;
- vfio_pci_write_config(pdev, vdev->pm_cap + PCI_PM_CTRL, pmcsr, 2);
+ vfio_pci_write_config(pdev, pdev->pm_cap + PCI_PM_CTRL, pmcsr, 2);
/* vfio handles the necessary delay here */
- pmcsr = vfio_pci_read_config(pdev, vdev->pm_cap + PCI_PM_CTRL, 2);
+ pmcsr = vfio_pci_read_config(pdev, pdev->pm_cap + PCI_PM_CTRL, 2);
state = pmcsr & PCI_PM_CTRL_STATE_MASK;
if (state) {
error_report("vfio: Unable to power on device, stuck in D%d",
@@ -160,7 +160,6 @@ struct VFIOPCIDevice {
int32_t bootindex;
uint32_t igd_gms;
OffAutoPCIBAR msix_relo;
- uint8_t pm_cap;
uint8_t nv_gpudirect_clique;
bool pci_aer;
bool req_enabled;
This is now redundant to PCIDevice.pm_cap. Cc: Cédric Le Goater <clg@redhat.com> Signed-off-by: Alex Williamson <alex.williamson@redhat.com> --- hw/vfio/pci.c | 9 ++++----- hw/vfio/pci.h | 1 - 2 files changed, 4 insertions(+), 6 deletions(-)